[Larry Sapp]

My top carb. was leaking gas, so I took it to the shop and payed for carbs. cleaning !When I took it out to the lake it would not accelerate to wot..jiggle linkage and it took off and ran ok..next outing it ran fine, last outing was running wot and running fine then the engine just bogged down and would not regain max rpm's. I don't want to go back to shop as it has been several mths. ago when work was done!Also I used Seafoam Deep Creek to decarb eng. any connection there ?? Thanks for your input.....Larry

[Elmer Fudge]

sounds to me like the problem might be with the float or the inlet needle.

[jim dozier]

Get a manual and check the synchronization between the throttle linkage for each carb and the linkage between the carbs and the ignition timing. If the carbs were off they might need resynching.

[Larry Sapp]

Thanks EF and jimd for your input , that gives me a starting point this weekend and I do have the Clymer but it seems a little vague in the trouble shooting section for my particular ailment ..Thanks Larry