have following issue. engine alarm. have replaced oil module,oilsender sensor, oil resovoir sensor, heat sensor. and alrm. the green wire from the oil module goes to post on ignition swith manual hard to read. can anyone tell me if the green wire goes to same post as the green/white wire. i may have them hooked up wrong.
jwr44,I have a 1994 Mariner 200hp. My manual shows the green wire coming of the Lubalert module. It goes from there to a bottom terminal on the Outer switch box. Another green runs from that terminal to ignition coil number Two. Hope this helps they should be about the same.ED
JWR44,My motor diagram may be different than yours. The bottom line is the green wire and the green/white wire are different. They go to different places. They eventually go to different ignition coils. Sorry I can't help any more than that.ED
switch iisue 200 hp mariner 1996
I have a 1994 Mariner 200hp. My manual shows the green wire coming of the Lubalert module. It goes from there to a bottom terminal on the Outer switch box. Another green runs from that terminal to ignition coil number Two. Hope this helps they should be about the same.
Linear Mode
