Search results

  1. N

    Yamaha 1986 pro-v carb specs

    I need the carb specs for a 86 pro-v 150. Carb is 6J900. My manual says pilot screw 1-1 1/4 out except if it is a pro-v then its 1 1/4 to 1 3/4 port and 3/4 to 1 1/4 starboard....and for other models throu 86 with carb 6g400 its 2 1/8-2 5/8. Last year i tried with the pro-v settings and it...
  2. N

    1986 ProV 150 timing

    Try too make a short story...bought this boat that sat for a couple of years, took the carbs off to clean and inspect....floats were off by quite a bit not too mention the pilot screws as well. So I think okay someobody has been tinkering with it. I check the timing plate, its spot...
  3. N

    1986 Pro-V 150 wiring between oil tank and thermo switch

    Hi all, I've been lurking on this forum a while now...lots of helpful info. Anyhow I bought a fixer upper 19ft alumacraft with the prov 150 on it. Took it out for a quick test run, runs good, idles like crap but it had been sitting for 2 years. Doing some maintenance on it, cleaned the carbs...
  4. N

    1989 Force 50 tilt/trim motor

    I have the tilt trim assembly without the motor from a 1989 force 50 that I'm going to convert to my 1989 force 35. The serial on the 50 is 507y9b. I've looked at some motors but havn't found anything before 1990 for the lower 35,40,50 force motors. It looks like it has 3 mounting bolts. I...
Top