Search results

  1. P

    prop help

    I have a 1992 17" nitro with 1992 evinrude 115. Now it has a 19 pitch 13" 3 blade prop..It works great with boat loaded on the lite side ( me with fishing tackle).But with another person and full ice chest its slow getting on plane.My question is , if I drop down to a slower pitch what would...
  2. P

    1992 evinrude shifter cable

    shifter cable broken will not move shifter.this is a concealed side mount unit.how do I get shift handle off. Anyone done this cable replacement ?
  3. P

    broken skeg

    1992 115 Rude.Bent skeg on bottom looks like a "J" and about 2 inches broke off the end.Any way it can be heated enough to straighten then weld on skeg replacement.Is the skeg replacement solid or is it hollow so it can slip over old broken one before welding?
  4. P

    76 115 hp

    Pulled my dads boat to lake this weekend. This motor was running 5 days ago but when we tried to start it saturday it never fired.No fire at plugs or coil.Could a coil or trigger go bad just sitting on the trailer.A tech told him years ago not tocharge battery with cables hooked up it would...
  5. P

    92 Rude 115

    purchased a new tach I was told it would work on a 12 pole which my old tach is set on.I was going to install it today no 12 pole setting.It has these settings. 6p 5p 8c/4p 3p/6c 2p/4c will any of these settings work for a 12 pole setup. its a teleflex tach same brand as my old one.
  6. P

    vented prop

    I can't believe the difference.I have read about venting a prop on this site for a while so I tried it.This boat will jump up on plane quicker than it has in a long time.Thanks for the tip.d:)
  7. P

    jack plate

    What is too high? When boat is trimmed and on plane the cavatation plate is about 2" out of water. The trim travel is getting pretty short before prop starts sucking air.I am thinking about dropping it down a little what do you think.
  8. P

    what the deal

    I replyed to a post it came back with " this forum does not exist".I am reading this forum so it must exist.....
  9. P

    1992 115hp rude

    Again.<br />I had another post going about this rig and alot of help was gave.I have tried everything and the hole shot is still terrible.I have done the following so far.<br />1.soaked carbs/new kits<br />2.set link and sinc<br />3.new power pack<br />4.new plugs ( champions)<br />5.took it to...
  10. P

    ballistic ss props

    Any opinions on Ballistic ss props? I have one on a 1992 115hp rude 13 3/8 x 19.I can't tell much difference.<br />Another question, will a tach for an 4 cyc. auto work on a outboard?
  11. P

    ballistic ss props

    Any opinions on Ballistic ss props? I have one on a 1992 115hp rude 13 3/8 x 19.I can't tell much difference.<br />Another question, will a tach for an 4 cyc. auto work on a outboard?
  12. P

    1978 115 merc

    turn key engine starts run about 5 seconds dies like you cut the key off.The motor ran fine last time about 3 months ago.He ( my dads boat) cleaned carbs but its the same thing.I don't know if he soaked them or not.I think its a ignition/electric problem.I don't think it would burn all the gas...
  13. P

    whats this

    What does VRO and OMS stand for.I was checking spark plug chart and it had a note about using different plug for engine with VRO/OMS.
  14. P

    1992 -115hp

    This is my 1st post and it may be too long.I bought this rig (17' Nitro) new in July 1992.In March of 1993 oil injector stopped and the engine locked up.The dealer(Fin&Feather)replaced bad parts and bored the engine.That engine ran great until 1995 engine locked up and they replaced complete...
Top