Search results

  1. T

    Leaking Carb.

    1983 115hp mercury is leaking/squirting gass out of carb number 2. It is coming out of a screw that has a hole in the middle of it and is located on the side of the carb. What may be causing this?
  2. T

    1983 115hp Mercury bogging down or choke problem?

    I just bought a 1983 115 v6 and it starts but will not idle unless i have at least half throttle and when i hit the choke it revs real high for a few seconds. Do you think is it a choke issue or what?
  3. T

    1974 115hp - Replacing the reverse gear or bearing..

    I thing the reverse gear of bearing is out. Any helpfull hints on removing and replacing. Can I leave the lower unit attached? or is it easier or required to remove it?
  4. T

    1974 115hp not going all the way into reverse.

    I just change the water pump. I can't get it to go completly into reverse. The prop turns just a little but makes a clanking noise all the time like it is not all the way in reverse. It goes forward ok but feels like it jumps into gear. What could I have done wrong or could there be a...
  5. T

    1974 115hp Mercury - with new waterpump.

    I replaced the waterpump and don't know how much water should be coming out of the little hole. I ran it both in gear and in neutral. Warter comes out but no more that a water foutain. How should it be coming out?
  6. T

    Help with changing water pump on a 1974 Mercury 115.

    I bought a 1974 115hp that has not been in the water in 10 years. I got the moter running, but i think i need to replace the water pump. I hooked it up to my water hose and started it. I did have some water coming out of the spout but not a hard stream. Any suggestions or tips?
  7. T

    Hydraulic problem on 1974 Mercury 115.

    I just bougt a boat that has not been in the water for a while. I got the motor working but the Hydralic lift is not workworking. It does not even make a noise. I checked and it is getting power to the solenoid but nothing. Any suggestions? Also what is the red rubber plug that has 3 slots for?
  8. T

    1974 Mercury 115 has not been in the water in 10 years..

    I just bought a 1973 Cheetah with a 1974 115. It has been out of the water for 10 years and not covered. I am replacing some bad wires before I try to start it. Any hints on other things I should check first? And what fuel/oil ratio do I need? There are some wiring that comes out of one side...
  9. T

    1985 DT75 Suzuki - Need Help!!!!

    1985 DT75 Suzuki motor runs real rough at low RPMs/Idle & in gear. It is so rough it shakes the boat. The higher the RPM the smother it runs. I just bought the boat so not sure how much it had been used. I checked the compression. #1 and 3 tested 150 PSI and #2 holds only 90 psi. It starts easy...
  10. T

    1985 DT75 Suzuki runs real rough at low RPMs/Idle & in gear. #2 cylinder low

    1985 DT75 Suzuki motor runs real rough at low RPMs/Idle & in gear. It is so rough it shakes the boat. The higher the RPM the smother it runs. I just bought the boat so not sure how much it had been used. I checked the compression. #1 and 3 tested 150 PSI and #2 holds only 90 psi. It starts...
Top