Search results

  1. E

    40 hp Johnson, Fuel filter runs dry

    Good morning guys, have an 40 hp Model # J40 0ElENJ Fuel filter will not stay full.... replaced all fuel line and fittings, replaced primer bulb, replaced vro with fuel pump, and fuel runs dry in fuel filter?
  2. E

    NGK Plugs instead of champion

    Can you substitute NGK BR8hs for Champion QL78C on a 92 40 hp Johnson? Thanks Ed
  3. E

    70hp tlrc sneezing and coughing

    servicing a 70 hp tlrc... engine would start and run then stall on a hose..... pulled carbs apart, bottom carb was ugly.... have cleaned and checked all 3.... have soaked and cleaned bottom 4 times now...engine will now start and run on a hose but sneezes, suspect it will not run under a...
  4. E

    95 150 Ocean Pro timing

    I have performed sync and link on 95 Ocean Pro 150 twice in the past 3 months. Runs great for 3 or 4 fishing trips than loses timing and timing knock returns at 3000+ rpms ? Any Ideas? Thanks Ed
  5. E

    2001 Yamaha 150 HPDI falls on its face

    guys, I have a 01 150 HPDI that will fall on it's face when I give it the throttle out of the water with no load. checked water seperator filter, checked filter on motor, checked filter in VST, still wants to fall on its face. Any ideas? Thanks Ed
  6. E

    95 Ocean Pro 150 1200 -1300 idle rpm

    Hi guys, Have a 95 Ocean Pro 150 idling 1200 - 1300 rpm out of water/ in water 1000rpm and 850 in gear. Rebuilt carbs ( they were spotless) shot timing, not sure what it should be. Below pointer says 20 degrees BTDC. Have done all of sync and link accept timing moved low speed tab for timing...
  7. E

    moved 150 to other boat

    Moved 150 hp to another boat. Finished wiring and hooked to battery with no key in ignition and engine started cranking on it's own. could the the 2 red yellows at remote be crossed? had to cut and splice - since they both looked the same. Thanks Ed
  8. E

    99 V150 falls on its face

    I have a 99 Yamaha V150 Saltwater edition. Idles fine, but when you go to WOT, it will not run above 3000 rpm. Try to go wide open and it falls on its face, but does not die. Can throttle up to 3000rpm Thanks ermess
  9. E

    95 150 Ocean runner mid range miss?

    I have a 95 150 Ocean runner that starts and idles at 1200rpm out of the water. She has good hole shot, but when you get to about 3000 rpm she seems to have a miss (almost like a car diesaling) this goes on between 3000 rpm and about 4200 rpm. Once you get her above that she runs fine. WOT...
  10. E

    92 60 hp Johnson won't stay running

    Outboard hard to start, when started - will run for 5-10 seconds and stop, even if you raise warmup lever for more rpm same results. Cleaned carbs, checked spark, checked compression, changed plugs Oil has been bypassed on VRO. See air bubbles at clear fitting between carbs and VRO when engine...
  11. E

    1988 Johnson 120 hp idles to high and misfires

    1988 Johnson 120hp Idles to high and misfires. Checked compression, spark, idexed flywheel, checked idle timing, - what should idle timing be on this motor? Is this a carb issue? Thanks Ed
  12. E

    2000 150 Vmax trouble starting

    Customer has a 2000 150 VMAX runs fine for a couple of hours stopping and starting drift fishing the flats of S. Texas, but, then she doesnt want to start. Engine turns over and after awhile we can finally get her started. Recently replaced water pump, previous tech runs NGK BR8hs instead of...
  13. E

    ProV150 noisy shifting into fwd & rev

    Installed new control cables (restoration job) adjusted out of water. Put boat in water, noisy shifting into reverse, bring back to neutral-no noise, shift into forward noisy shifting into forward, shift back to neutral no noise. Do I need to adjust something else or is this a lower unit issue...
  14. E

    Steering Cable Replacement

    Does anyone know how to remove a steering cable on a teleflex Safe T Helm. I pulled the pin, but cable will not pull out. Any ideas Thanks ERMESS
  15. E

    2001 90 hp Johnson rough at 3000rpm

    90 hp idles fine, put it in gear and bring to 3000rpm engine sounds really rough, bring it to WOT she smooths out and runs fine. Take her out of gear and bring rpms up to 3000 she sounds smooth. When running in gear at 3000 rpm sound seems to get worse when steering back and forth. Plugs look...
  16. E

    Yamaha V150 Stuck in Down Position

    Hey guys, Have a V150 stuck in the down position, release valve will not turn. any suggestions on how I can get this engine up. Electrical motor sounds OK, but was trying to lift engine so I could check fluid level. Thanks Ed
  17. E

    2000 Sea Doo GTX starter removal

    What is the best way to remove a starter on a 2000 Sea Doo GTX.<br />Thanks<br />Ed
  18. E

    2000 Yamaha 150 hp 2stroke no top end

    2000 Yamaha 150 hp 2stroke no top end,good compression, good spark, timing right on the money,at idle sprayed fuel down throat of each carb with two plug wires off, each carb bogged like it is supposed too. Ran motor without cowling and flame arrestor, fuel spray thru emulsion tubes looks good...
  19. E

    95 DT 75 2000 rpm at idle

    engine idle speed 2000rpm<br />good spark<br />compression 150,150,130<br />intruduce fuel #1 engine bogs,<br />#2 engine bogs a little<br />#3 engine does not change at all.<br />remove #3 spark plug wire no affect on engine speed<br />I am leaning towards pulling carbs and cleaning, but am...
  20. E

    NO Spark - Replace Power Pak

    Johnson-J70PLSSD<br />Followed my trusty CDI IGNITION Troubleshooting<br />Peak Voltage Tests<br />Brown to Brown/Yellow - 305V<br />Orange to Orange/Black - 22.3V<br />Blue to White .6V<br />Purple to White .7V<br />Green to White .7V<br />Checked continuity on Stop Circuit and uplugged.<br...
Top