Search results

  1. R

    How do I wire Minn-Kota power Drive v1 co-pilot to a v2 control board?

    My control board from 2003 power drive died. I ordered the v2 control board and need help with which wires go where for the speed control? I can turn left/right and also turn prop on & off with remote, just no speed control. Any help would be greatly appreciated. Hope someone is up late who can...
  2. R

    4.3 GXI-D Engine Alignment SX-M Drive

    I recently rebuilt my engine and reinstalled. After installation I couldn't get the engine to align, so I bought an alignment tool. After trying to make adjustments at motor mounts to align, I noticed the rear engine mount washers and bolt were loose. I realized that when tightening the lock...
  3. R

    Cracked Block or Bad Riser?

    Last winter I failed to properly winterize my boat. Doesn't typically get cold where I live but last winter was unusually cold. I went to prep my boat for it's first outing and noticed water shoot out of my manifolds. After some inspection, I noticed the cylinder heads were cracked as well. The...
  4. R

    4.3 GXI-D Wiring Diagram

    I am having an issue with the ignition on this engine. I currently have no power at the coil. Does anyone know where I can get the wiring diagram for this? Any ideas or similar experience? ​Thanks
  5. R

    4.3 GXi-D Ignition timing

    Hey all. I am trying to determine what the ignition timing is for this engine. The operators manual gets specific for the A/B model but not D. I replaced cylinder heads, lapped the valves, torqued heads to spec and did the valve lash torque adjustment at 22 pounds following steps when exhaust is...
Top