Search results

  1. R

    Side Panels

    Hi I have a 97 Mariah Z 276 I want to remove interior to send to upholster to be refinished the seats are easy but the side panels have no visible attach points they are vinyl with a button in middle every foot or so the buttons unscrew I thought maybe a plastic insert like a car door but when...
  2. R

    Breaker

    Hi I have a 40 amp breaker right at battery that goes to the 30 amp main breaker on 12volt panel is it necessary seems like overkill to me thanks
  3. R

    SX Shift cable grommets

    Does anyone know the part number or where I can find the parts mine are missing and I think that would cause my small leak 5.7 GSI SX-M drive grommets are at outdrive Thanks
  4. R

    Galley Removal

    Hi I have 87 Wellcraft Antigua 265 and the galley was removed and replaced with a bench and storage out of a couple sheets of plywood. Ive seen pictures of the galley looks like it would have weighed more than what was built. I was wondering should I add some weight as the original design was...
  5. R

    Boat goes on sideways

    Hi I have a 87 Wellcraft Antigua on a 91 Magic Loader trailer the boat always went on sideways noticed all keel rollers were shot replaced all with boat on trailer one self centering and 3 regular. When winching onto trailer boat is tilted to starboard what adjustment do I need to make to fix...
  6. R

    5.7 gsi iac

    Does anyone know the part number for idle air control valve for 5.7GSI PWTR 3843750 is not the same as original and doesn’t fit Thanks
  7. R

    5.7GSI Idle speed

    Hi after some new valves engine running great only issue is idle.It goes from 1000 to 700 and back doesn’t stall and no hesitation on acceleration just won’t stay steady it is fuel injected 5.7GSIPWTR What should I look for?
  8. R

    One Cylinder Running Rich

    Hi 5.7GSIPWTR Had a misfire checked heads had 3 bad valves had them replaced as well as seals and guides and machined both heads. New plugs,wires,cap, and rotor. Engine not running right plugs look ok except 6 is carbon fouled. Compression 170 on all cylinders. Leakdown on 6 is 35% and on 1 is...
  9. R

    5.7 GSI Misfire

    Hi 5.7GSI PWTR Engine Misfire new plugs wires and cap all plugs normal except number 6 loaded with carbon. When I started it up to warm up for compression test had lifter noise for about 20 seconds and then went away and misfire didn't start at first as soon as temp gauge started o move. Engine...
  10. R

    5.7 GSI running issue

    Hi 87 Wellcraft Antigua 5.7 GSI SX-M drive So had her out today and lost engine It would not start while waiting for a tow did some investigation found the wiring harness 10 pin connector at relay box on starboard side is very touchy if I just touch it cuts out fuel pump I was able to get home...
  11. R

    5.7 GSI Initial distributer timing seting

    I have a 5.7 GSI changed intake gaskets motor was moved with distributer out how do I set initial distributer position and then how do I set timing I have an advance timing light
  12. R

    Marine Toilet

    I have an 87 Wellcraft Antigua does anyone know what kind of toilet came with them? Need a new joker valve and numbers have long since worn off.
  13. R

    oil level increase 5.7 GSI

    Hi 2000 Volvo 5.7 GSI when I got it oil level was high I thought previous owner over filled I changed the oil and set level ran engine and checked again was good Ran engine for a while to winterize seems like a lot of fuel coming out of injectors and when I checked oil it was over filled. Oil...
  14. R

    5.7 GSI Cut Right Out

    87 Wellcraft Antigua 5.7 GSI Fuel Injected was cruising along at 4000 rpm when engine suddenly stalled and cut right out. I don't here the fuel pump when I turn ignition on will the relay go bad just like that and where is it located? Thanks
  15. R

    Damaged Lower unit

    Hello I have a 5.7 GSI Volvo Penta DP drive lower unit hit ground after winch hook failed and boat came off trailer.No visible damage to hull but lower unit has a hole in front on bottom as drive was trimmed al the way up at the time of impact. Can lower unit be welded and can water get into...
  16. R

    Stalls when switching to reverse

    Hi 89 Wellcraft 5.0 Mercruiser Alpha One Gen One Boat was stalling going in reverse end of last year put new shift cable in no matter how I set it same thing any ideas Thanks
  17. R

    Alpha One Shift Cable Replace

    I'm having trouble running inner shift cable through outer. The cable is new and the outer has been fed up to motor. The inner goes in about 10 inches then stops. When I run the old inner through new outer it goes right in all the way to motor any suggestions? 1989 Wellcraft 210 Classic 5.0...
  18. R

    Stalling in reverse

    Hello I have a 1989 Wellcraft 210 Classic 5.0L Mercruiser Alpha One Gen One When I try to go in reverse stalls out runs fine in forward and at idle doesn't make any strange noises will run at idle in reverse but when I give it gas it stalls does not in forward any ideas?
  19. R

    putting boat on trailer

    The last time I was taking boat out of water last time kept going on trailer listing to starboard could not straighten got o trailer but at a slight angle maybe 20 degrees any ideas why and how to correct Thanks
  20. R

    sterndrive water pump not working Alpha One

    Please Help had overheating problem went to change seawater pump looked fine changed any way started up ran good but when temp went up it went from zero to 220 instantly took apart impeller burned no water put old impeller back in new pump housing and put lower end in tub of water spun shaft...
Top