Search results

  1. K

    135 evinrude timer base

    still working on this black hole. 1973 135 evinrude time base not moving with the speed control,but I am able to move it by hand, what controls it,what should I look for that makes it advance and retract with the speed control.how does it work??
  2. K

    what year model is this????

    J150STLCT last letter e or maybe e serial # j5861533
  3. K

    1973 135 evinrude-- power tilt and trim

    my power tilt and trim motor has quit working. Coming from the relays I have power but motor is in down position.How do you raise it up to get to the ptt motor.how do you remove it to get it repaired or replaced.also can you recommend someone to work on them.I would aperciate any advice i can...
  4. K

    fuel issues 135 Evinrude

    compression 120 all cyl. good spark.will start but will not keep running.took carb. bowl off and blew out both carb.,all apeared to be clean.how ever i did not remove the jets. other than the float jet. when i pump the bulb it never get's hard it remains spongy.Is there any good way to verfiy...
  5. K

    power pack 1975 135 eviinrude

    should terminal 1 have power on it and if so where does it come from.my does not with or without the switch on even when cranking.sensor coils 1&3 7.5 ohms 2&4 8.0 ohms. no short to ground. charging coils 837 ohms. no spark any where.replace all coils as 1 was bad. terminals 2,4,9,12 has...
  6. K

    1976 ---135 evinrude no fire on 2&4

    has been setting for 3 yrs.new plugs and fresh gas.always ran carbs dry of gas when finished.started on muffs,hard to start but seamed to run fine.put on water hard to start and will not high idle. would only run half throtle.120 psi cimpression all cylinders.no fire on 2&4.sensor...
Top