Search results

  1. M

    Replacing Engine Mounts

    So I am getting ready to install my new stringers and engine mounts but I have no idea what the old engine mounts looked like since when I went to remove the old ones there was pretty much nothing left but saw dust and wood chips. this is what it looked like before I opened up the fiberglass...
  2. M

    Bedding Stringers Question

    Ok so i looked everywhere for this information. and i know what my options to bed my stringers with and to leave about a 1/4" gap between the stringer and the hull. I saw a video made by Friscoboater he used 1/4" pieces of foam to sit the stringers on to make the gap and put PL. but my questions...
  3. M

    need advice on a repair

    I was removing my stringers during my boat restore and my tool went through my boat :blue: just wanted some advice on what the best option to repairing this is. some info on the boat its an 84 doral 19" original gel coat. any help would be appreciated. thanks here r the pics of the inside and...
  4. M

    removing open bow

    hi there, I am doing a restoration of a 19' Doral classic with an open bow. I am at the stage of ripping up the floor due to rot. my question is how do I go about getting to the floor under the bow its all fiberglass. do I just cut out the section and fiberglass it in when I'm done? I'm new to...
  5. M

    Newbie question!

    I'm really new to boats but have been a mechanic for 10 years so i have good knowledge in general of many types or mechanics. I took my stern drive off to replace a seal (i had to separate the top half from the bottom to change it) and now I'm trying to put the drive back on the boat but I fear...
  6. M

    Shift Slide question

    hi i'm new to the forum and I searched around but am still confused. my shift slide broke and i'm looking to replace it. now I know there is 2 models of cable with a round end and one with a hexagonal end. my cable has a hex and the shift slide has a 2 stamped on it which if I read correctly is...
Top