Search results

  1. T

    Prop for 26' cruiser / Bravo 2

    I'm looking for a bit of help upgrading my prop. Boat is a Crownline 250CR, 26' LOA about 7000lb dry. 7.4L with a Bravo 2. Present prop is an aluminum 17.75" x 21P 3 blade. Goes just over 40MPH @ 4500RPM which is in spec. Holds plane at 23MPH @ 3400. I often have 6+ people and their gear...
  2. T

    95 Bravo 2 Trim Solenoid

    Have a 95 Merc 7.4 with a bravo 2. SN OF558xxx (can't remember right now). I think my 'up' solenoid is going out. It will click everytime but not power the pump until I excercise it several times. Same with trailer switch. Does anyone know the right part number for the trim pump solenoid? The...
  3. T

    What's growing on my outdrive?

    Any marine biologists? I just repainted this out drive with Rustoleum Pro and spent the last 4 days on the Allegheny river. Found this on the drive. It comes off easily enough with your finger but does leave a trace it was there, and it seems to be attracted to the magnesium anodes and other...
  4. T

    Carbureted 7.4 dies after cruise, fine at slow speed

    Looking for some diagnosis help so that I know what to check in finding this problem. Boat: Merc 7.4 carbed / B-2 Issue: Boat will cruise for a few miles and then lose power, cut out and die. It will then not restart until it has sat for approximately 10 minutes, after which it does restart...
  5. T

    Crownline 250CR cockpit floor repair

    I'm looking for some insight as to the most effective way to repair the cockpit floor. It is soft and springy over the left half where the walkway is and I surmise that the core is wet. It seems that the most likely point of water entry was the bolts which secure the captain's seat. This is the...
  6. T

    Bravo II bellows and cleanup questions

    Hey all, I'm about halfway through a bellows and gimbal bearing change out on a 95 Crownline 250 with a 7.4 / B2. I'm going to repaint the outdrive, but I'm also now looking at the transom assembly and steering yoke and they appear to be corroded and could use a painting too. The trouble is I...
Top