Search results

  1. S

    DP-S Transom seal?

    Well Ive got a DP-S that is leaking water into the boat. It is so hard to see down in there. I thought the leak was the seal where the Y pipe attaches. I pulled the motor and replaced the Y pipe seal. It is still leaking. My bellows are dry. I filled the boat up with water to just under the...
  2. S

    Do boats use an o2 sensor?

    Just curious here. I got to thinking about my motor. Im not sure if I have a o2 sensor. I have a 97 Volvo 7.4 LK model. How does the motor adjust the fuel and timing if it doesnt measure the unburned gases? I know it uses a map sensor but I cant seem to find an o2 sensor on the exhaust side. I...
  3. S

    Trim up only works when tilt is pressed. Volvo DP LK

    Hello all, I am trying to figure out my trim/tilt on my boat. I have the wiring diagram and am trying to figure out why it will only go up when I press both both the tilt and trim up switches. Trim will not work on its own. I am thinking I might have a bad sending unit. Has anybody ever ran into...
  4. S

    Seat filler cushion pole support?

    Hello I have a 1997 Chris Craft 27 Concept. In the back I have two filler cushions that can be installed to form a bed. It has two poles that I install and then just lay the cushions on top of the poles. I am looking to buy two more of the small plastic pieces that the poles lay on. I just do...
  5. S

    volvo sx/dp exhaust bellow snap ring?

    Hello all, over the winter I took my SX/DP outdrive off blasted it and refinished it. Tonight I reinstalled it on the boat. I didnt put the exhaust bellow in until after I mounted the drive. So I have no way of installing the snap ring for the exhaust bellow. I installed it without the snap ring...
  6. S

    Trying to split a DP-S in half

    Anyone have any tips on how to split the upper and lower halves of a DP-S? I removed the four nuts and two screws the volvo manual says. It does not budge at all.
  7. S

    Wiring Diagram 1997 Concept Cuddy 27

    Anyone know where I can find a wiring diagram for a 1997 Chris Craft concept 27? When I open the access covers to the boat there are a couple plug ends that I am trying to figure out what they belong to. I would like to install whatever is missing. The first one is behind the left front seat...
  8. S

    DPS seal inbetween upper and lower?

    Hello. Is there a seal inbetween the upper and lower cases on a DPS? I was wanting to split mine apart to repaint it and could not find the seal in the parts diagram. Can anyone confirm if there is one or not? Thanks Mike
  9. S

    water in DP-S outdrive

    Well I drianed my outdrive oil and it came out brown. What are the seals that need to keep the water out? Thanks Mike
  10. S

    Volvo penta/OMC outdrive ID?

    Hello all I am new so please bare with me. I just purchased a 1997 Chris Craft 27 concept. Well it looks like the drive has never had the bellows replaced. They are very old and cracked all over. I dont believe that they are leaking. But I would like to order new ones to replace them. My issue...
  11. S

    Hello new guy with a couple questions

    Hello. First off I would like to say this seems like a really nice forum. When I am searching on google I keep coming across this forum. So I figured I would post a couple questions. I am looking to buy a 1997 Chris Craft Concept 27. The problem I am running into is where do I buy parts for it...
Top