Search results

  1. J

    Cobra sx Stern drive leaking gear oil from between the upper and lower

    Need help has anyone ever experienced this.? I know there is a seal between the two. Could it be something else.
  2. J

    Cobra sx Stern drive leaking gear oil from between the upper and lower

    Oil leak on Stern drive between upper and lower. Is it the O ring?
  3. J

    Stern drive trim switch

    This happened once before a year and a half ago all the sudden my trim won't go up or down. I ran a jumper wire the last time this happened and I was able to get it to operate. Then all of a sudden it started working again. Until now. Any ideas on what's going on is it the switch? Relay? Thanks...
  4. J

    1996 Volvo Penta 5.0fi were can I find a water pump?

    its starting to leak and i know it will only be a matter of time before it goes out. the pump that brings water to the motor. not sure of the correct name?
  5. J

    Shift cable replacement help?

    Hi all, I have a 1996 Volvo Penta 5.0fi with a six cobra stern drive, have a question I'm changing out my cable I pulled the old one out with a wire connected to it so when I pull the new one through. I'm planing on taping the wire to the cable and help up it through. Do I have the right idea...
  6. J

    Control/shift cable ax cobra 1996

    Good afternoon, was wondering what is the easiest way to feed a new control/shift cable from engine compartment to stern drive . I pulled the old one out and pull some tie wire with it so I would have something to help guide the cable through. Do I tape the wire to cable? I,m worried it may ship...
  7. J

    water in cylinders

    If you use the wrong ear muffs and cover up weep hole on side of the out driver on an 89 omc 4.3 cobra can water be forced up into cylinders any hydro lock motor ??? Or is there something else happening ive never had this problem before ,i removed spark And bled water out and ran it with no...
  8. J

    water in gear oil on sx outdrive

    hey guys, does any one have pictures of what good oil looks like or if it has a little water in it. i sampled oil because i have a few drops leaking from prop shaft. any help would be grateful , thanks Jon Z
  9. J

    lower sx 1996 drive prop shaft leak

    Any tricks I should be aware of before I replace shaft seal and o ring. Any special tools needed. Have soloc manual , it does not explain procedure but has expanded view. Any help would be great, thanks in advance. Jon
  10. J

    fuel gauge

    hi to all, not sure were to post this . i have a 1996 gs 205 glastron. some of you know i've been having trouble with my fuel gauge. haven't tried fixing it yet just dealing without it . well today out on the water it was getting late so i turn on all of the accessaries light etc. and i...
  11. J

    rub rail repair

    Hi, I have a 1996 glastron gs 205 the rub rail needs to be re connected it became seperated from side up by the port helm needs to be re screwed down I need to remove rubber/plastic strip from channel all the way back from the aft. I can get it out but I can see it going to be tuff getting it...
  12. J

    fuel gauge below empty

    Hey guys, I all confussion of my last mistake, lot track of post on fuel gauge. It reads below empty no matter how much fuel I have in the tank. Glastron gs 205 1996. How do I test to see if its the gauge or the sender. Thanks for any reply. Jonz
  13. J

    best manual

    Hey guys, quick question best manual for 1995 5.0fi volvo penta engine model #pncsce. thanks jonz
  14. J

    ignition is dead

    I was testing my fuel gauge put wire on purple wire on gauge and grounded it on fuse bus now I get nothing on any of the gauges and ignition will not crank engine and the boat ran fine last week did I fry computer. I checked all fuses on fuse block and there good are there any fuses in engine...
  15. J

    fuel gauge reads empty

    I bought a 96 glastron gs 205 and the gas gauge reads empty is it the gauge or sender how do l test. Thanks for any replies. Jon
Top