Search results

  1. B

    sync lower unit an shifter

    Ok I change the water pump on my 2002 ,125 elpto mercury I put the lower unit back in an now my gear shift control is out of sync with lower end ,I stared it up an it was in forward gear how do you sync lower end an your gear shifter
  2. B

    charging

    I bought 2 energizer E29hm deep cycle batteries they had 12.4 volts in one & 12.2 in the other ,i put my noco 3 bank 30 amp 10 per bank battery charger on them & they are up to 14.50 & 14.47 my question is how high should they go before it shuts off ,they 125 amp hr ,840ca, 675 cc amp. thanks...
  3. B

    Putty

    Ok what is that stuff called & where can i get it that you put around your wires that comes up from the bottom of the boat that goes in your sealed compartment where you keep your life jackets ,my wires for my trolling motor comes up Thur that hole & i need to seal it off to keep water out of...
  4. B

    amps

    I have a minn kota fortrex 80# us2 52" shaft i am still hooking it up to my pontoon boat my question is i can't find how many amps this thing draws ,i havent bought the batteries yet it is 24 volt i just trying to figure out which batteries to get with the best amp hours with out braking the...
  5. B

    Upholstery

    What is a good Naugahyde vinyl weight for pontoon seating ,I don't want it hard an brittle but soft an durable with all the protections like UV ,cold crack scratch res., mildew, non fade, an use a good thread to sew it with. I have a 24df sweetwater that i need to have re upholstered & what...
  6. B

    Upholstery

    What is a good Naugahyde vinyl weight for pontoon seating ,I don't want it hard an brittle but soft an durable with all the protections like UV ,cold crack scratch res., mildew, non fade, an use a good thread to sew it with. I have a 24df sweetwater that i need to have re upholstered & what...
  7. B

    on board chargers

    Question for battery (GURU) What is a good dependable on board charger, maintainer ? but not to expensive i'am not cheap but i'am retired, for a 24 volt system i plan on using the trolling motor minn kota fortrex 80# that is installed on a 24' pontoon, for about 3 to 6 hours aday for about a...
  8. B

    Trolling motor

    Hi i am going to buy a minn kota fortrex 80# bow mount but my question is what shaft length 45" or 52" i have a 24' sweetwater pontoon the fence & gate is on the edge in front ,any body know if the shaft is adjustable or stationary , any help would be appreciated , on another note i do live in...
Top