Search results

  1. B

    Outboard oils

    Im looking to buy drums of oil and cut out all the Gallons and Quarts , what oil would cover Honda , Mercury , Mercruiser and Yamaha ? Could I use regular aoutmotive oil ? Does it have to be a Synthetic Blend or could I go for regular oil ?
  2. B

    225 Yamaha engine codes

    I just redid the oil pump on my 225 ( 2005 ) and she ran great on the sea trial , today I went down and the engine light is flashing . At first there was 3 and then 9 flashes , I turned the batt off and then started the engine again and now Im getting 4 and then 5 flashes . Does anybody know how...
  3. B

    300 hp Etecs PTT issues

    Hi there . Ive got twin 300 Etecs and when I tilt down the motore they shudder and bounce like crazy , Ive greased all the lube points and no difference . Could there be something wrong internally , any ideas ?
  4. B

    Cat 3128 Injector setting

    Ive got twin 3128 in a boat and Ive been told the injectors need setting .How difficult is it to do this and what tools are required ?
  5. B

    BF 225 honda fault codes

    Could anyone please tell me where I can get the fault codes for this engine , the codes were 115 and 114 ?Ive ordered a manual but cant wait .Thanks guys
  6. B

    1998 250 hp hohnson ignition problem

    Ive got this motor and it will only run if you hold the starter in , the moment you let go she dies . Got voltage on purple wire , bypassed the neutral safety switch and no change . Any ideas ?
  7. B

    200 Hp Yamaha flat spot

    My motor runs great from start up to WOT , if I bring my rpm down to keep her running on plain and then hit the throttle again she has a flat spot for a second and then she takes and runs great again . Ive cleaned the carbs , my fuel is clean . Any ideas ?
  8. B

    50 HP Honda not reving

    Ive got a 2010 50 HP Honda and I cant get the engine to rev more than around 3500 rpm , Ive checked the fuel filters , fuel lines and primer bulb . Ive run the motor under load and in neutral , could it be the TPS sensor . There are no alarms sounding or any visual problems . Any ideas ?
  9. B

    Yanmar 6LP-STE wont idle

    This engine wont idle under 1000 rpm , when I come back to neutral it will shut off and I have to give it throttle to get it started again . Sometimes it will shut down around 1500 -1800 when I start throttling down . Ive changed all the filters , washers , swopped the primer pumps over , ran it...
  10. B

    2006 Honda 90 hp carb issues

    I pulled the carbs off my engine and cleaned them , then I only had # 1 2 firing so I cleaned the bottom 2 carbs again and now I have # 1 2 3 firing but not # 4 , Ive got good spark and compession , any ideas ? There cant be any dirt left in te carb so Im outta ideas .
  11. B

    90 hp Optimax VST voltage low

    Ive got a 2008 90 hp optimax and Im only getting 4.9 volts to the fuel pump , aparently the 115 hp had this problem . Has anybody heard of this or is there a bulletin out from Mercury ?
  12. B

    225 Optimax overheat alarm

    Ive got a 1999 225 Optimax , if i run under 2000 rpm she runs great but aything over that and after about 2 miles the overheat will sound and the light will come on . The boat has the old 4 gauge style , any ideas ? The merc tec has a CDI programme but it wont read on this engine as its to old .
  13. B

    250hp yamah alarms

    Ive got two 250 yamahas and when i come of the plain and idle to the dock ive alarms sounding . A guy ran a scan and it showed the air sensors were faulty , swopped them out and still no change , but now I got nobody to run a scan to check for cods again . Any ideas ?
  14. B

    4.3L Mercruiser milky oil

    Ive got a mercruiser 4.3 , the oil had water in it . I changed the manifolds and risers , did a compression test and it seemed fine . Did 3 hrs on the boat and have water in the oil again , any ideas ?
  15. B

    2006 Honda 90 hp milky oil

    Ive got a 90 honda , the engine oil was milky , it was running bad so I did a compression test and found # 3 cyl was low it was also overheating so I pulled the cyl head . There is a 2 inch hole between the exhaust and water jacket , the head gskt seemed ok . Could there be a cracked block ...
  16. B

    200hp honda trim pump issues

    Ive got a 200 honda , replaced the rod guides , seals and manual releif valve . the tilt works ok but the trim side is not working , I can hear the motor running but it wont trim up . Sometimes when going down I can hear the motor running but nothing happens then i trim up a bit and it will...
  17. B

    350 mpi

    Ive got a Sea ray with a 350 MPI and at 2500 - 3000 rpm she is surging , Ive changed the fuel regulator and am still getting between 38 and 43 psi fuel pressure under load . Ive found what I think is a fuel shut off solenoid wich is not connected to 12v . o these motors need a low pressure pump...
  18. B

    2003 merc 90 hp

    Do these engines only fire on 2 cyl on idle , itsseems to run a bit rough on idle and misfires around 2500 rpm , rns great after that . Any ideas ?
  19. B

    150 Honda fuel pump wont run

    Ive got a 150 honda thats fuel tank got flooded with water , ive drained the tank cleaned the fuel lines to the HP fuel pump and drained the HP pump . Ive got no voltage going to the pump , does this run through the relay or could it be the kill switch ? I dont have a manual or wiring schematic...
  20. B

    350 mercruiser

    Ive got a 350 mercruiser that runs great at WOT but the engine seems to surge/hunt at 2500 to 3000 rpm , my fuel pressure is at 38 psi and then drops to around 34 psi under load . Any ideas ?
Top