Search results

  1. codykoke

    1956 johnson 15 hp

    The motor ran perfect for over an hour then I shut it off and wouldn't start. Back home there was no spark. Any suggetions
  2. codykoke

    wizard powermatic 12

    I just picked up a wizard model Wm?a( not sure what the 3rd digit is). Serial is 831170. My first question is what year is it. Second will mark 25 coils of the same year. 3rd what is the fuel mixture
  3. codykoke

    Cruise a day leaks

    I have a pressure tank that leaks fuel when you push the metal primer down it squirts out by the shaft. The diaphram looks perfect. Is there a sealant i can use temporarily until i get the new diaphram?
  4. codykoke

    1964 mercury 9.8 110 fuel mix

    Im primarily an omc guy and I just got this motor. My '65 uses 50:1 and my '50's use 16:1 so what does this one use 32:1?
  5. codykoke

    1947 sea king 3 hp

    I picked up this motor, got it running but can't figure out carb setting which needle is low speed? It also has a tube on the starboard side that looks like a tell tale but oil/fuel come out its weird that it sprays fuel on the exhaust housing and makes a mess. Any input is appreciated
  6. codykoke

    1956 Johnson fd-10 lower unit

    I am working on my friends fd-10 long shaft but at some point it was changed to a short shaft evinrude lower unit. My problem is I need a lower unit seal kit. Will the kit for an fd-11 fit.
  7. codykoke

    1965 sea king 6 hp lower unit seal

    I need to find a lower unit seal kit for a 1965 sea king (Chrysler) 6 hp outboard. Any leads are appreciated
  8. codykoke

    1965 Chrysler sea king lower unit seals

    My 1965 sea king 6 hp has a sea foam green gel in the exhaust housing that leaks out. I thought it was lower unit lube whipped with water but when I removed the vent and fill plugs the lube was brown with water droplets in it. Is the green gel just unburned oil with water or lower unit lube...
  9. codykoke

    eska sportfisher 3.5

    i just picked up an eska sportfisher 3.5 hp. model 7132b I am wondering where if needed could i buy carb kit and ignition parts?
  10. codykoke

    1954 evinrude fleetwin recoil spring

    I dug out the fleetwin today and remembered that it needs a new recoil spring. If anyone can point me in the right direction that would be great.
  11. codykoke

    1957 johnson 18 hp runs rough

    I took this motor out for the first time after carb kit new coils and impeller. It ran fine for the first 20 minutes then started stumbling every few seconds. Adjusting the carb does not help. I'm wondering if a small leak in the tank around one of the bolts could cause this but the filter bowl...
  12. codykoke

    1957 johnson fd-11 18 hp ignition

    I just picked up this motor and to my surprise the coils have been replaced already,but when I do a resistance check on them they have different resistances. They are different brands. Is this a problem. One is about 4.5 k ohms the other is about 7 k ohms or so.
  13. codykoke

    1955 fastwin ignition concerns

    I have a 1955 fastwin im trying to get running. On the first attempt i had spark in only one cylinder. I took it apart and checked resistance from plug boot to ground, I found one had no continuity so i Fixed it by connecting spark wire to coil and then the both sparked and had 4.5 k ohms in...
  14. codykoke

    siezed powerhead- 1955-56 evinrude 15hp

    picked up this motor from a guy for free. got it home and pulled the head and its rusted solid in there, and appears to be full of sand, what would be the best way to get this free? id like to try to get it running as the ignition has all been replaced already, but if not got a good parts motor.
  15. codykoke

    New Motor-What Year and model

    I know this is the johnson/evinrude forum but I bought a sea king I believe to be a gale/OMC product. I bought this motor for 20$ and I cant find a model # or serial #. the faded tank decal says 3.0 hp at 3500 rpm. it is an opposed twin cylinder and has large plugs. there is no recoil starter...
  16. codykoke

    Blown Rod!!! 1954 evinrude fleetwin 7.5

    I finally got the carb kit and took her to the lake to set needles. Ran fine and pured like a kitten then all of a sudden. chink and it banged to the side. so long story short i blew a rod and would like to know where or if they're still available or if im dead in the water. I already have $250...
  17. codykoke

    1954 evinrude fleetwin 7.5 pdf manual

    Hello all. I have a 1954 evinrude fleetwin 7.5 and am looking for a pdf manual EDIT. any help appreciated Please read the rules, cody. No soliciting and no Email.
  18. codykoke

    need help-evinrude fleetwin 7.5 bogs at 3/4 throttle

    my 1994 evinrude fleetwin 7.5 bogs down at 3/4 throttle. Ive heard this could be a broken shock absorber in the gear case, but is it possible that the high speed needle on carb is not adjusted causing this. any help appreciated.
  19. codykoke

    ignition tune up kit

    I have a 1954 Evinrude fleetwin 7.5 and need a tune up kit with condensers and points. Does anybody know if the Sierra kit for 1956-58 7.5 hp will work, or if there is a place to get the correct kit.
  20. codykoke

    1954 Evinrude fleetwin 7.5 lower unit

    hello all. This is my first post and my first outboard restoration. I recently bought a 1954 fleetwin 7.5 and would like to check the impeller but cannot figure out how to remove the lower unit. I have already removed the bolts to the lower unit but cannot find a way to get the shift link off. I...
Top