Search results

  1. S

    1996 OMC 5.0 EFi long crank when hot

    I have had my 1996 Chris Craft Concept 19 with a 5.0 OMC Cobra fuel injected engine since May 2016. The last few times i've taken it out, the boat starts right up. If I shut it off and then start it within a few minutes, its fine, but if I park it for a while, say 30-90 minutes, it takes 10-20...
  2. S

    Inline Fuel Filter VP 5.0L EFI

    I recently purchased a 1996 CC Concept 19 with the 5.0L Ford EFI. There is an inline plastic fuel filter just under the intake manifold. Is this supposed to be there? I can't find a part# for this but I did see it in an online picture of a similar engine (pic below) Thanks, Steve
  3. S

    Accessing raw water impeller '97 CC Concept 19'

    Just bought a 1997 CC Concept 190. 5.0L MFI engine. PO unsure of last impeller change so I'd like to go ahead a do that. Looks like it would be a lot easier if I could remove the rear bench seat. Anybody have any idea how it comes out?
  4. S

    1973 merc 500 prop shaft seal and o-ring repair

    So, how hard is it to change the oil seal and o-ring on the prop shaft on a 1973 50 HP merc? Assuming I can get the bearing retaining nut off, is it just a matter of pulling the bearing carrier out, replacing the seals, and reinstalling? Is there any kind of adjustment needed? Any crazy parts...
  5. S

    1973 Merc 500 water tube seal missing?

    I am putting a new water pump impeller in my 50 hp merc and noticed that connection between the water pump outlet (the notched, conical riser on top of the pump) and the bottom end of the tube going up into the top of the engine doesn't seem to be tight. There is a washer inside the upper pump...
Top