Search results

  1. A

    Whale tail cause for cavitation Yes or No

    14'classic wood runabout cavitates during high speed turns. I am running a short shaft 1960 evenrude Lark II 40hp with a Whale tail. <br />Any suggestions?
  2. A

    14' SeaMac Runabout Long vs. Short Shaft

    I have both a long and short shaft 1960 Evenrude Lark II for my 14'classic wood boat. I'm not sure which one to use (performance wise)?
  3. A

    1960 40hp Evenrude Lark II Lower Unit

    What type of oil should be used in the lower unit?
  4. A

    1960 40hp Evenrude Lark II Flush Kit

    Is there a way to run a flush kit off of my hose or do I need to always fill up a barrel to run the engine?<br />Is the water intake the small screen located just above the cavitation plate or is it within the housing above?
  5. A

    1960 40hp Evenrude Lark II Ignition Cutout

    I recently installed a new ignition switch. I have power going to it and one wire going to the solenoid. The engine cranks fine but how do I set up a kill-switch? Sould there be a wire running to ground off the ingniton switch? :confused:
  6. A

    1960 Evenrude Lark II 40 hp NO SPARK!

    This engine was fully tuned at a marina 2 years ago and has not been run since. I cannot seem to get spark. NEW:Coils, Points, Condensers, Wires, Plugs. I have detached the wiring harnes and cranked it by hand and I have also tried detaching the wires from the cut out switch. Still nothing...
Top