Search results

  1. V

    Suzuki DF250 Flushing Mystery

    Hi All, I am confused! I have a DF250 2011 which has flush plugs at both rear and front of the engine so i can connect my fresh water hose and flush it. I always used to flush it from the forward plug and the water then comes from the pilot hole and I always flush the engine after each use...
  2. V

    help! VolvoTAMD41-P on a Beneteau 8.8 does not reach max rpm but reaches max speed

    hello folks, I have bought a new boat, and I know the engine which is on it has a max rpm of 3800 - when doing fast idle it does go all the way to that but when under load (in gear) the max rpm is around 3000 - the design speed is 22knots and at 3000rpm it does reach that speed no problem - is...
  3. V

    Yamaha F225hp Flushing Question

    Hello my friends - I have a question regarding flushing the F225 - I usually use the muffs and leave the engine running for 5-10 min but the new marina which I am going to take it to makes it quite difficult to flush (no rear pontoons) so I tried flushing it from the adapter hose from the...
  4. V

    HELP ME! PLEASE! Yamaha 60hp FETO Wet Bottom Spark PLug

    Hi. My engine runs well, idles well, high/low RPM, everything OK. BUT I noticed that it burns MORE fuel than normal, it is like 50% more and I noticed smell of unburnt fuel from my engine. So I opened the hood and there is no sign of leak, from hoses/filter/ etc. and I decided open the...
  5. V

    Yamaha 60hp FETO Autolube Question

    Hi Guys, I have recently purchased a boat which has an oil injection system (Autolube). Previousely I owned an engine which I had to pre-mix oil+fuel 50:1 ratio. I am a bit curious about the oil consumption on Autolube system. I filled the oil tank and after burning about 15ltr of Petrol it...
  6. V

    HELP! Evinrude 70hp only starts with Cold start primer solenoid

    I have a problem, my Evinrude 70hp only starts (cold start) using the Cold start primer solenoid. But once it starts once and engine warms up, I can re-start the engine without using the Cold start primer solenoid. However, if I disconnect the fuel line and leave the engine works to empty the...
Top