Search results

  1. F

    Honda 225 spark plugs not firing

    I have a 2003 Honda 225 on a 27 foot Premier Pontoon. The motor only had 38 hours when I got it and now has 89 hours. I had an issue where it would not run on all cylinders and was running really rich and fouling spark plugs. I ended up taking it to a dealer and the 02 sensor was replaced. Even...
  2. F

    Honda 225 running poorly. Feels like it is only on four cylinders

    I have a 2003 Honda 225 that I just purchased on a Premier Pontoon boat. The engine only has 50 hours on it. When I first put it in the water it felt like it was running on four cylinders, then after it ran a few minutes it kicked in the other 2 cylinders and ran good. It would run about 5700...
  3. F

    What year is my Evinrude 150

    I have an Evinrude 150 60 degree motor, but I can't find any numbers in any of the places I have been told to look. I thought it was a 93 model, But when I ordered piston rings for it the rings were both the same thickness. My motor has a wider ring at the top of the piston and a narrower one...
  4. F

    Johnson 150 reinstalling pistons

    I have rebuilt many small block and Big Block Chevrolets over the years, but I am rebuilding my first outboard, a 1993 150 HP looper, and have a question. In the seloc instruction manual it says you have to use a special tool to center the rod on the crankshft before you tighten it. How...
  5. F

    1999 50hp JOHNSON-ROUGH IDLE

    Just bought a little 17 foot metal boat with a 50 HP Johnson (1999 model two stroke) The motor starts great and runs good above about 2000 to 2500 rpm but when I slow down it idles very rough and the motorshakes badly like its running on one cylinder. Any ideas?
Top