Search results

  1. M

    Need winshield for 1965 starcraft boat

    does anyone know where I might find a new windshield for this boat? thanks markojr
  2. M

    HELP! 1983 volvo penta aq225d 280 sterndirve overheating

    i just installed a new thermostat and impeller. backwashed the water lines and the engine still overheats.. runs ok at up to 22 rpm under 180 temp when i get to 25 - 30 rpm plus temp gauge goes up to 240 degrees. when i throttle back to 22rpms or less temp gauge drops down to under 180...
  3. M

    looking for Northbeach

    Hey NB I have not received my id plate for my 1965 starcraft. do you still have it? can you send it to me thanks john
  4. M

    1983 Bayliner 2150 cuddy cabin - speedometer

    I have Volvo Penta i/o. when I first accelerate the speedomoter wont register any spped until I hit about 30 rpm's ....is this normal? Any help would be aprreciated Thanks Marko
  5. M

    Looking for NORTHBEACH for new id plate

    Northbeach, w.ross said you may be making new id plates. I have a 1965 naussau 16 foot i am redoing(see my post) it is missing the id plate. w.ross gave me this info; 75 horse, 6 people at 150lbs or 1300lbs for people gear and motor. can you make a new one for me? thanks Marko
  6. M

    electric start 25 hp jonson 1990 e25telesb How to start

    I tried to start this last week. pumped the bulb, pulled out choke and pushed starter. turned over once than that was it...just keep trying to start. any ideas??? New gas and oil. thanks in advance for your help. John
  7. M

    removing steering wheel

    I have a 1983 bayliner 2150 cuddy cabin. I am trying to remove my old steering wheel to replace it with a new one. I removed the center hub cove. Unscrewed the 2 side nuts and bolts, removed the center lug nut.....and i can't pull the old sterring wheel off. am i missing anything? do you...
  8. M

    1965 restoration 16 ft

    hi I have attached some picures of the ongoing reno. can anyone tell me the name of my starcraft boat model. i beleive its a 1965 also there is a hole in the keel on the bottom looks like its supposed be there, does it belong??? see pictures with screwdriver stiking in hole. thanks more...
  9. M

    lower unit compatability

    Hi, I have a 1975 Johnson 60 hp, eslc outboard. will a lower unit from a 65 hp Evinrude outboard w/ controls be compatable with this outboard. Mine is electroshift not sure about the 65 hp one. thanks for any info. John
  10. M

    tilting a 60 hp Johnsonson motor while driving

    i just purchased a 1971 60hp johnson model # 60esl-71c is there a lever that allows you to tilt the motor up while you are driving other than the cotter pin bolt on the back of the engine? any assistance would be appreciated. thanks
Top