Search results

  1. stevetedder

    Water pump... Somethings not right

    Just changed the water pump assembly on my 84 JohnsonV4 90hp and now water is shooting out along where the lower unit bolts on to the midsection and also some water is flowing out of the shift linkage hole also. I took it back apart and verified everything was put together properly and the only...
  2. stevetedder

    House boat construction question....

    Re: House boat constuction question.... Re: House boat constuction question.... Thanks, oops!, I dug out enough of the rotten wood to see that the one by's are stapled at the top to the top plate. It seems the two options on replacing it are to either figure out how the roof is screwed and...
  3. stevetedder

    House boat construction question....

    Re: House boat constuction question.... Re: House boat constuction question.... OK , Finally got back to this project. Lets hope not on the roof removal. Got some better pics.Pic number one is the side wall of the roof.A fiberglass retaining clip/plug was through the hole in the middle and it...
  4. stevetedder

    Show Yer Boat II

    Re: Show Yer Boat II Got a new to me one that fell in my lap to show off this week. 1993 30ft little Hobo House boat with a 90HP nissan on the back. Appears to have minimal usage. Interior looks new.Minor repairs needed, parts on the way. Cant wait to put it in the water for test run. And my...
  5. stevetedder

    Correct operateing temp

    I have a 84 for model 90hp johnson V4 bought a thermostat kit about a month ago and finally installed it today. Infrared thermometer shows the power head temp to be about 140-150 degrees now.It didnt occur to me to check the temp before. Does this seem about right? Or too Hot? Im pretty sure I...
  6. stevetedder

    Alarm/Buzzer going off, uh what now?

    I have around a 93 model 90hp NS90 nissan 2 stroke motor that the alarm is going off. Tell tale port is pumping water and there is plenty of oil in it. The alarm is going off anytime it is in gear even while the motor is not running. Ive seen the online owners manual from Nissan and it says what...
  7. stevetedder

    House boat construction question....

    Just bought this 93 little hobo 30 ft'er and just behind the edges of the fiberglass top appear to be one by's that run all around it. Problem is they are deteriorated and need replaced. Any Ideas on how to go about this without removing the whole roof?
  8. stevetedder

    Just want to make sure.....

    As you can tell from the pic I am replacing a steering cable. Ive got it moving and think it will come on out but before I do I wanted to make sure that it is coming out the right way.I mean the tube that is sliding out in the pic is supposed to come on out right? Being a support and pivot point...
  9. stevetedder

    WHat the %^$^&$ ?

    An almost unbelievable trip 120 miles to the TN river a couple of weeks ago. Left home on what should have been a 2 1/2 hr trip towing my pontoon boat on a tandem trailer. I stopped for on-board fuel around mile 25 and upon checking the tires seen one of my trailer tires was starting to throw a...
  10. stevetedder

    Why am I not clear on this?

    Should be easily found in my manual but doesn't seem to be the case. Not sure when or if thermostat has ever been changed in my '84 90hp V4, and its on my list to do as PM , but I am unclear as to the location and procedure for checking/replacing it. Any help or diagrams on this is appreciated.
  11. stevetedder

    Boating the MS river

    Re: Boating the MS river Well I finally did it, couldnt resist the temptation any longer. Must say it was an interesting trip, not what I would call a leisurely cruise and not for the faint of heart. The current wasnt necessarily all that strong but the water was very turbulent. It felt as...
  12. stevetedder

    General carb question....

    When the throttle control lever is all the way forward WOT position, shoulnt the butterflies on the carbs be wide open? mine are barely open, should I adjust this?
  13. stevetedder

    Johnson V4 Fuel pump swap

    Re: Johnson V4 Fuel pump swap Took a sec to figure out how to upload images here could be a little more user friendly..... ]
  14. stevetedder

    Johnson V4 Fuel pump swap

    Ok so Ive come to the conclusion the VRO fuel pump is bad. Since the engine is already set up for premix fuel can I skip out on the $400 VRO pump and somehow install a regular Johnson outboard fuel pump($100) from a older motor? If so, where does the vacuum for the pump come from? How does it...
  15. stevetedder

    84'Johnson 90HP V4 not drawing fuel ??

    Title says it all, motor starts to die out, hit the primer bulb a couple of times and it revs back up. Checked the draw lines in tank for air leak, tightened clamps around filters and checked diaphram in VRO fuel pump. Any other thoughts? something simple Im overlooking? Any thoughts are...
  16. stevetedder

    What Years did they make"Chrysler"Outboards?

    Anybody know? Best I can tell is 69-84. Sound right? specifically 70-150 HP but any info here helps
  17. stevetedder

    PWC NOOB Questions

    OK Im totally new to PWC and had a few questions. I just bought a 95 seadoo gtx 700?750? and a polaris 650 sl .60 lbs compression on front cylinder of sea doo. Question is What is a fair price for an overhaul on this ski? Memphis,Tn Question 2: 95 polaris 650 sl has a burnt wiring harness (2...
  18. stevetedder

    Found this thought I would share......

    http://www.wakeweather.com/
  19. stevetedder

    Should I Pass/Jump on this one?

    1978 winner runabout. Johnson 85hp motor, new battery, new starter, carbs just cleaned, new seats. Includes 2 gas tanks, and muffs to run out of water. $1250 What the ad didnt say is there are two putty filled holes in it or is this an easy fix in general? Not sure exactly where or how big as I...
  20. stevetedder

    Over weighted?/Transom deflectors?

    Upon turning and when I start to accelerate before I get on plane I see some water creeping past the back seat, Boat seems to sit pretty low in the back, but not over the deck low. A couple of weeks ago I pulled the plug on the toons, out of one nothing, the other, around 20 gallons (from many...
Top