Search results

  1. K

    Help Me ID Brass Nipple on Int. Manifold '99 Evin. 70 HP 4 Stroke

    There are 2 nipple fittings on the aluminum intake manifold. One is an elbow pointing upward that connects to a hose from the silencer. The other is a brass straight nipple that points directly toward the throttle body and it's the one that I'm asking about. On the used boat/ motor I just...
  2. K

    Help Me ID This Nipple on Intake Manifold- Missing Part? '99 Evinrude 70HP 4 Stroke

    I noticed a squealing noise that I originally thought was a bad belt tensioner bearing. Instead; it's an (open to atomosphere) brass nipple, that is on the front of the intake manifold, pointing to starboard directly at the silencer and throttle body. The nipple would take a 3/8" hose. I can't...
  3. K

    Belt Squealing Noise @ Idle - 1999 Evin 70 HP 4 STRK S/A Suzuki DF70

    Can anybody give me some clues as to what might cause a noise that sounds like a squealing fan beltat idle? Possibly the bearing in the timing belt tensioner? Runs fine otherwise. Engine has 325 hrs. Bought a service manual from BRP and couldn't be more disappointed. Is the service manual from...
  4. K

    1999 Evinrude 70 HP 4 Stroke- Squeeling Bearing Sound at Idle

    I have just bought a used boat w/ an Evinrude 1999 70 HP 4 stroke motor (w/ 325 hours) that has a detectable "squeeling bearing" or "loose fan belt" noise at idle. First thing that came to mind (because of my lack of experience with this outboard) is the timing belt because it sounded like a...
  5. K

    Where to Buy Evinrude Hood Decals Listed as "Not Available"

    Is there a source for engine cover decals that are listed as "not available" on BRP's website? BRP's website states the starboard is available but not the port side for a 1999 70 HP. Port side decals are not available for 2000 or 2001 70 HP models either. Any ideas?
  6. K

    '79 15 HP Johnson Water Circ. Question- Overheating

    I have just replaced the water pump impeller and did some other maintenance on the motor over the winter. I started the motor (for the first time after servicing) on the back of my boat at the launching ramp. Water discharge was excellent out of the 2 exhaust' water ports just below the lower...
  7. K

    '79 15HP Proper Install Manual Recoil Assy

    My first post and it's because I need help. :rolleyes: My question is how to install the recoil assy (recoil spring, cup, starter pinion, starter pulley) into it's proper position. I've read another post that mentioned placing the metal tab on the bottom of the cup into the hole in the casting...
Top