Search results

  1. C

    tmd

    i was talking to u about cylinder head gasket i took the boat in to marine shop they did a compression check to start 165 psi on all cylinders within small variance on a couple,but they noticed some water geting in to the cylinders,they said the head gasket was leaking but not into the...
  2. C

    cylinder head gasket

    1997 120 hp force ,detailed tips on removing and replacing cylinder head gasket,do i leave the cylinder head cover attached to the cylinder head since it looks like its two parts?,and far as gasket sealer that blue stuff use that in addittion with the gasket? .do i put it on both sides of the...
  3. C

    sea foam deep creep

    when decaroning to u also pull the spark plugs an spray in the cylinders
  4. C

    tmd

    hypothedical question,say i did have a leak in the head gasket wouldnt it burn white smoke threw the exhaust like on a car,or steam?gonna run the boat tommorrow ill look and see if leaks around the gasket.theres alittle water at the bottom of the cowling is that typical?turned the idle up do i...
  5. C

    cylinder head temp sensor

    97 force 120hp outboard overheat temp sensor is a snap ring in a recessed area ,how do i test to see if it is operating properly.thanks u guys for all your help,hope there is a boat heaven,need to send u guys a pound cake,jeff
  6. C

    cylinder head gasket

    have a 97 force 120 hp outboard,noticed a small leak from cylinder head gasket,could this leak water into the cylinder.how much damage could happen if i ignored.should i pull the spark plug to check for water.or should i replace the head gasket,any suggestions on how to do.thanks to ya all.jeff
  7. C

    compression check

    gonna do a compression check,what kind of reading should i have and differences between cylinders,1997 120 hp force
  8. C

    compression check

    how do u do a compression check 4 cylinder force 120hp 1997
  9. C

    low speed jets

    hi,i aked earlier about low speed jets and where they were located,i saw the mixture screws ,there was a plastic screw on the top which i took out and there was a slotted screw inside about 3 eights of an inch in could this be the low speed jet,if so what should they be adjusted to,this is a 120...
  10. C

    carb

    what is lean and what is rich
  11. C

    TMD

    WHERE ARE THE LOW SPEED JETS,ARE THEY INSIDE THE CARB,120 HP FORCE 1997
  12. C

    carbs

    have a 97 force 120 hp force,question how many turns out from seat for mixture screws and idle screw,2 carberators,thanks to anyone that can help
  13. C

    testing the solenoid

    how to test the solenoid and test the starter and what voltage should it read,while cranking or running
  14. C

    testing the solenoid

    testing a solenoid on a 120 hp force 1997 motor ,should i have 12 volts at the lead that goes back to the switch when the key is on to the start position.or let me know how to test the solenoid
  15. C

    starting problem

    have a 1997 120hp force exlpt,problem is hesitation before starter motor cranks or get nothing at all when key is turned.looking for some expert advice from a fellow american.thanks for your time an consideration,jeff
Top