Search results

  1. C

    80 hp OB wiring schematic

    anybody have a wiring schematic they can send me for a 80 hp Mercury Marine outboard? #146383 I'm currently at the water working from my mobile device not my pc Thanks
  2. C

    factory manuals

    I downloaded a couple mercury repair manuals from this website a few years back went to go do some Electrical work on my boat tried to open Up the manual forgot that it's password protected and a RAR file can anybody tell me what the password is to open It up? thanks for your time
  3. C

    1968 Merc 1000 shift cable and waterpump kit

    I've got a 1968 Mercury 1000 on the back of a 18' sterncraft getting ready to do some repairs: change the water pump impeller and or the kit if it needs it service the lower end while I have it apart also the shift cable housing on one end is starting to crack and fray so I'm trying to locate...
  4. C

    70 hp yamaha wont idle correctly, no power off idle when load tested, etc...

    1989 70 hp yamaha wont idle correctly, no power off idle when load tested, etc... Just bought used that's been sitting in storage for a couple of years Compression seems to be ok 120 took the carbs off and cleaned along with clean fuel & additives the jets in the carbs were contaminated to...
  5. C

    Replacing center piston on a 50 hp Mercury(3 cyclinder) 2005

    Getting ready to replace the center/middle piston on a 50 hp mercury(3 cylinder) can someone tell me if the power head will need to be removed, crankshaft will need to come out, etc... any ideas how many hours this will take, what it would cost to have a shop do the job, etc... At this point...
  6. C

    Cylinder #1 spark plug exploded could water injestion be the culprit?

    2007 3.0 inline 4 cylinder mercruiser The weather's been warming up in my area so i decided to get the boat out of storage when I went to fire it up it it was misfiring and wouldn't run very good at first I thought it was a stuck choke, loading up, etc... so I was going to open that up and...
  7. C

    2004 Skeeter VX22 200hp F.I. wiring schematic

    I've got a 2004 Skeeter VX22 200Hp yamaha Electrical system has been acting up took it out for a run it died then wouldn't crank back up (cranking too slow) had to get a tow back in the system has 3 batteries which are all new with the on board charger plugged in 2 of the green lights light up...
  8. C

    2009 mercruiser 3.0 that keeps eating starters

    I've got a 2009 mercruiser 3.0 that keeps eating starters it originally had the factory starter on it but broke one of the main mounting bolts had to drill it out replaced with new starter bolts & installed new aftermarket starter(ARCO) that's supposed to be of good quality 2nd time around my...
  9. C

    15 hp johnson won't start

    I've got a 15hp Johnson that won't start early 1990's pull start only already took carb off and thuroughly cleaned, visually checked all jets carb sprayed passage ways to verify, etc... the plastic cam roller that opens the throttle was broken, that was replaced, took the front part of the fuel...
  10. C

    1995 Yamaha 55hp 2 cylinder C55TLRS

    Having some problems with my outboard first it was idling crappy and running bad over all I removed the carbs and thuroughly cleaned them the bottom carb had a bunch of blackish looking sediment in it almost looked like something had broken down in the fuel system and then ended up in the bottom...
  11. C

    Twin 115 HP Mercury Outboards steering is stuck & leaking

    I'm looking at purchasing a 21 Ft Bayliner Trophy Cuddy Twin 115 HP Mercury Outboards but the steering is stuck and leaking Any idea of what it will cost to fix the problem approximately- ballpark - best guess, etc...? I want to buy the boat but concerned about repair cost don't want to get...
  12. C

    13 hp Yanmar diesel

    I'm currently helping a friend get his 2 cyclinder 13 hp yanmar diesel engine(2GMF) in his sail boat going It's been sitting for 5 years plus he mentioned that another person that previously tried to help accidentally hooked the battery up backwards but realized it pretty quickly & it was...
  13. C

    50 hp force overheated

    I have a 50 hp force outboard that overheated & has lost power from that I've been told that one of the pistons could be distorted from this, or blown head gasket & now might have loss of compression Anybody have an aproximate what it will cost to have the top end of this engine repaired/redone...
Top