Search results

  1. S

    Logic 2000 Live well

    Does anyone know how to remove the Logic 2002 boat Livewell?
  2. S

    Check engine light and alarm goes on

    Hi, My 2000 150 hp Johnson alarm and check engine light goes on when I'm at 29 rpm. I slow down and the alarm and light goes off. The motor never stalls or shows any signs of failure. What could it be? Thank you.
  3. S

    2000 Johnson 150 hp Trim/Tilt

    Hi, Today the trim/tilt was working fine. When I got home the motor did not go up. I switched relays (Has Two) both worked for the down direction. I guess that discarded the relay being bad. I released the pressure and raised the motor to check the fluid. It had fluid. Tighten the screw again...
  4. S

    How to bypass vro oil pump johnson outboard 150 hp

    Does anyone know how to bypass the VRO oil pump 2000 Johnson outboard 150 hp?
  5. S

    Flush Valve inlet

    Hi, My Honda 1997-4 Stroke-90hp today began to throw water out of the Flush valve inlet (this is where I flush the engine with out having to turn it on) picture attached. This is the first time this happens. This is the diagram. any help will be appreciated. I have the shop/manual, but it...
  6. S

    Apelco VHF Radio

    I have a apelco 4500 plus VHF Radio. Was working fine. Now, it receives well, however when I try to transmit the display flashes and I get a clicking noise (click, click, click). Basically its not transmitting. Any idea to what is causing this?:confused:
  7. S

    HONDA 90hp TRIM GAUGE

    hi, I have an honda 4 stroke 90 hp (1997). I'm having problems with the HONDA TRIM GAUGE. I turn the key (power) the guage needle moves, but when I trim the engine it doesn't level out. I leveled the boat out, while on the trailer, but the guage needles stay down. Do I have to be on actual...
  8. S

    1997 Honda 90hp 4 stroke

    Hello to all; I just changed out my engine from yamaha 85hp to a Honda 90 4 stroke. Runs great and all. My question is what is a good rpm cruising speed? I've never had a four stroke outboard and I can use all the good advice out there. Thanks:redface:
  9. S

    Engine stalls

    :confused:I got a 85hp yamaha. It stalls at sart up and while running it stalled on me and turned off. It starts up after a few minutes, but I need to choke it a few times while shifting to foward it runs a few then stalls until it turns off. Any idea whats causing this? I changed the spark...
  10. S

    3.3hp 2002 Mercury

    Hello everyone, I just bought a used 2002 3.3hp Mercury. It turns right up and seems to have a lot of power. I did notice that the water being pumped out was not that steady. Is this normal on these small engines or could it be a bad or time to change the water impeller? Thanks to all!:redface:
  11. S

    Tune up!

    :redface: Hi, I have an 1993 Yamaha 85hp. Just boat it and it works great! But , there's also a but, I don't know the date of the last tune up? I want to do it , but what do I need? Coils, Sparks , water seperator filter ? Also on the coils, can they be tested? Any help on tuning my engine up...
  12. S

    Speed Problem?

    :confused: hi to all! I have a 91 johnson/ 90 hp. Starts up great, and starts to run great. Seconds after moving and slowly excelerating the engie kind a jerks and slows down . I then have to press choke and it then picks up speed. But while picking up speed It constantly keeps jerking and I...
  13. S

    Johnso 90HP 1991yr

    :redface: Today I took the boat out after changing all 4 ignition coils , spark plugs and lower gear oil. Well, I went out and when I put it in shift (forward) it made grinding noise. But it ran! While running it will lose power and I had to keep pressing the choke button. Also while running it...
Top