Search results

  1. Y

    Gimbal Ring / Bell housing REMOVAL SX

    2006 Volvo Penta 5.0 Sx Trying to replace trim sender sensor Got this far and cant figure out how the gimbal ring comes off? The pin in the bottom I drew yellow arrow to is it pressed in or how is it removed? after this is removed will the whole ring slide back? for enough access to where to...
  2. Y

    2006 Stingray 200LS with Volvo Penta. Just bought and have some mechanical ?'s

    Does anyone know what pitch prop came factory on the boat? The one that is on it now has a ton of bottom end but runs way higher rpms than I am comfortable running on top end. The trim gauge needle is stuck in the all the way up position in the dash. I can get a smidge of movement out of it but...
  3. Y

    Volvo Penta Gimble Grease Tube Pulled Out From Gimble Housing

    I have read several threads on here about the zerk fitting pulling out of the tube that attaches to the gimbal bearing housing. but none about the whole tube pulling out. In my case the zerk fitting is still attached to the tube the tube just pulled out from the gimbal housing. Can I just tap...
  4. Y

    Constant Steady Alarm and Boat Wont Start

    I just bought a 2006 Stingray 20' with a Volvo penta 5.0 95 hours on her. Very excited! I have never had it in the water but when I bought it I started it on the trailer and half a crank fired up and ran perfect. Of course I just let it run for 5-10 seconds before shutting it off. I have done...
  5. Y

    1998 Yamaha Exciter Se Bogs Down After Turn Shut Down Mode??

    I Have A 1998 Yamaha Exciter Se That When You Go To Turn Sharp It Goes To What I Am Calling Shut Down Mode Where It Wont Throttle Up Just Goes About 3 Mph And Bogs Down, I Had One Guy Tell Me He Thinks Its The Oil Sending Unit And To Just Eliminate That All Together And Mix My Oil And Gas And...
Top