Search results

  1. C

    Merc 650 still no fire

    The sieral # is 4265448 which is what I found was a 1975. It started off losing fire on all cylinders then regained it for a couple trips on the water. After the second time it lost fire I jumped the gun and bought a new coil not thinking to run any tests to see what the problem was (I know...
  2. C

    '72 45HP Chrysler

    This has been a great motor since my Grandad bought it new. The problem I am having with it is when it is at a idel it pumps water fine. At full throttle it doesn't. I checked the impeller and it is fine, the keeper that holds the impeller in place is still there. The head gasket was leaking...
  3. C

    1975 65HP merc

    I am not getting any fire out of my coil on this motor. I replaced the coil today and it fired a couple times then nothing. I hope it isn't something burning the coils up since it was $120 :rolleyes: Any ideas on what I should look in to next?
  4. C

    4.3 merc. fuel system problem?

    After blowing a hole in the #6 piston and endeing up replacing 2 piston and 4 valves on a remanufactured motor with around 15 hours on it. I got the motor back in the boat, aligned it, and finished the install of all the engine components. I pumped the 15 gallons of old fuel out and put 10 fresh...
  5. C

    4.3 Alignment

    I am trying to get my 4.3 back in the '87 Sea Ray. I had to rebuild the front motor mounts because of rot so I was expecting to have to adjust them for propper alignment. I was having trouble getting the tool into the back of the motor with the back motor mounts in and snug. I loosened them up...
  6. C

    Mercruiser parts

    I am wondering where the best place to get mercruiser parts for a 4.3. I am in need of a .30 over piston, rings, and one exhaust and one intake valve. Plenty of places I have found online dealers that carry lots of mercruiser parts but I can't seem to locate the above. I would like to buy the...
  7. C

    87 Sea Ray

    I have the motor out of my 87 Sea Ray Seville 19' CC. It is a 4.3 merc. When I removed the motor the leg bolts holding the motor mount down weren't holding well. I am guessing that whatever is inside the mounts that are fiberglass on the outside is rotten. Is there anything I can fill the mounts...
  8. C

    4.3 Merc

    I have a 87 4.3 that has a hole in the #6 piston. The guy I got the boat from had the same happen but I'm not sure what piston it was. The spark plug was broke and the valves looked to have been beaten by what I am guessing was part of the spark plug. I was thinking of just rebuilding the #6...
Top