Need Fuel Flow Diagram on 1980 Johnson 35hp Carb

[stillnotrunning]

I'm trying to clean the salt residue (looks like barnacle glue) out of the carburetor of a Johnson 35hp J35ELCSM. I thought I had taken it apart and rinsed it after it went under water in hurricane Ivan, but it looks like I didn't.
The carb is likely shot, but I wanted to do everything I could before trying to find something they don't seem to make anymore.

Any ideas on an actual fuel flow diagram for this carbuetor so that I can know how many fluid paths and ports I need to try to open? Any ideas on dissolving this stuff other than Evinrude Engine tuner (recommended by my local dealer)

If not, any ideas where I might be able to find a replacement carburetor.

Thanks!

 

[tashasdaddy]

Re: Need Fuel Flow Diagram on 1980 Johnson 35hp Carb

ebay and
Salvage yards.
sea-way.com
outboard-parts.com
laingsoutboards.com
tcoutboard.com
fairwindsmarina.com
salvagemarine.com
marinepartsoutlet.com
Superior Marine (800-338-9281)

 

[stillnotrunning]

Re: Need Fuel Flow Diagram on 1980 Johnson 35hp Carb

Thanks tashasdaddy, I'm amazed at how fast you reply. I'll check out those sites.

I do actually have a frozen motor I am using for parts, and the carb on it is in reasonable shape. However, the numbers are different, and the bowl portion doesn't include the solonoid bracket.

Do you know how I could find out the difference between part numbers?

original carb casting is 324331
potential replacement is 327479

I may be able to salvage the bowl portion (322299), but right now the center tube is fused to it.

Thanks again!