Ted williams 7.5 shifter lever

[twintrades]

Any one have a pic of the shifter lever set up on a 7.5 ted williams ??

I got one from the dump and the lever is conected fine on the outside. Just inside, should the little spring slid on the thin ( coat hanger size) rod conected to the lever ?

And should the spring/lever slide into the hole under the motor where it can reach. with the spring compressed on the little shaft. ?


If anyone could take a pic i would love it!!

Thanks

[twintrades]

No one had one ??

[winman99]

Here's an older Eska (same as TW in the day) shifter setup.
What is your model number?
You can also go to www3.sears.com and put in your model number to get a parts diagram.

[JIMMIKRON]

if it's a tecumseh the coathanger bent end fits into the shift handle and the strait end goes thru both loops on spring and up into the power head...