That I believe is your idle stabilizer..You cannot cut into it...must be a early 80's motor as they all do this....
That would be correct about the early 80s, I guess I'll just have to try and find a part of the wire that isn't corroded and splice into it. Thanks for letting me know what that thing was called, I couldn't find it on any diagrams.
Take it off and throw it away, check both timin' settings...............You MIGHT need ta set idle and max timing. You will know after its checked.
Last edited by Dukedog; February 22nd, 2014 at 08:53 AM.
Looks like you may have just enough wire left to make a soldered splice (covered with shrink tube, of course). And you're right about it being hard to find in the parts book- for some reason Merc decided this was part of the choke plate, not the ignition system. Go figger. The good news is that if you can't make the splice, the OEM part is still available. The bad news- $$$$, about 200 of them.
Wherever you go- there you are!
You dont need it, do like Dukedog suggested. These do go bad and cost more than $200 when engine pops!!!
When in doubt,Trim it out!!!
Business Owner & Certifed Technician
Boats I own & use
20ft Javlin w/250 Junkrude
17ft Bullet w/200 Merc (SOLD!!)
13ft Allison w/150 I-6
17ft Hydra-Sport 175GT
15ft Allison w/75 Stinger(project)
14 x 48 Drifter with 1100SS Merc
| Outboard Motor Topics
Outboard Motors: non-repair
| Boat Repair and Products
Boat Building and Repair
Fiberglass Boat Repair
Boat Trailers and Towing
| Boat Type Topics
Center Console Boats
Cuddy Cabin Boats
Fish and Ski Boats