Please note this thread has been inactive for 90 days. For the best results, please start a new thread.
May 22nd, 2010, 03:14 AM
#1
[OP]
Petty Officer 3rd Class
boat wont stay on pad"chine walking"
Can't drive through the chining
and when the boat is fully trimmed out the wheel does not have much if any bite to it.
18' bumble bee
150 mariner
4 blade prop
this happens at about 55-60 mph turning 5800 rpm
May 22nd, 2010, 03:21 AM
#2
Petty Officer 3rd Class
Re: boat wont stay on pad"chine walking"
Are you running your trim to high?
May 22nd, 2010, 03:22 AM
#3
Petty Officer 3rd Class
Re: boat wont stay on pad"chine walking"
May 22nd, 2010, 03:34 AM
#4
[OP]
Petty Officer 3rd Class
Re: boat wont stay on pad"chine walking"
Originally Posted by
abarron
Do you have ajack plate?
yes
May 22nd, 2010, 03:34 AM
#5
Petty Officer 1st Class
Re: boat wont stay on pad"chine walking"
just because ya got trim travel means ya gotta use it.....what plate,setback,height...and with a 4 blade?
May 22nd, 2010, 07:58 AM
#6
Admiral
Re: boat wont stay on pad"chine walking"
What's your steering setup?
Similar Threads
By bhanson in forum Boat Topics and Questions (not engine topics)
Replies: 36
Last Post: April 17th, 2011, 01:55 PM
By cheburashka in forum Mercruiser I/O & Inboard Engines & Outdrives
Replies: 1
Last Post: June 15th, 2009, 05:32 PM
By Hydrilla in forum Boat Restoration, Building, and Hull Repair
Replies: 14
Last Post: April 25th, 2008, 08:24 AM
By KCLOST in forum Boat Topics and Questions (not engine topics)
Replies: 7
Last Post: September 19th, 2006, 09:49 PM
By pmas701 in forum Johnson & Evinrude Outboards
Replies: 9
Last Post: May 9th, 2006, 10:28 AM
iboats Forum Directory - Over 100,000 forum posts organized by topic