Recent content by wili

  1. W

    No spark on bottom coil

    What's trigger?
  2. W

    No spark on bottom coil

    I have no spark on bottom coil on 2000 Johnson 60 hp. I Swapped the coil with another and the no spark stayed on bottom coil. What/how should I check now.
  3. W

    VRO O-ring?

    I took the fuel pump out to inspect due to some running issues and a small (maybe 1/4 inch) rubber o-ring fell out and I cannot find it in any of the parts diagrams. I believe it came from the side with the spring but I am unsure. Does anyone know where this o-ring is supposed to go? Not sure...
  4. W

    Motor missing at WOT

    I have a 2001 J40JPLSIA taht is missing at WOT. Will start and idle fine but when I give it throttle it starts missing and sometimes die. I have used CDI troublshooting guide, Ohms on the coils checked out. I checked resistance on the power pack but the color codes did not match on the CDI...
  5. W

    2001 Johnson J40jplsia

    Outboard missing out under load. Will start and idle fine but when I give it throttle it starts missing and sometimes die. I have used CDI troublshooting guide, Ohms on the coils checked out. I checked resistance on the power pack but the color codes did not match on the CDI troubleshooting...
  6. W

    Minn Kota 65 runs backward

    Motor runs backward, I changed polarity of the feed wires then it would not turn. I have found through a search that I may need to switch polarity at the circuit board. Can anyone tell me which two wires to swap?
  7. W

    Minn kota maxxum 74 parts schematic

    I am wanting to shorten the shaft on my trolling motor and replace the shaft bearings and am in need of a parts schematic. Does anyone know where I could locate one? I have trie Minn Kota website but it asks for a password to get to the documents.
  8. W

    Approx weight of motor

    I have a 2001 Johnson 60 horse motor. Can anyone tell me the approx. weight of this motor? I am wanted to take the motor off to adjust the height. Thanks Pat
  9. W

    Steering cable replacement

    I am in need of replacing the two steering cables on my 1986 Ranger 371v. I have read that in order to replace you need to remove the motor. Is this true and if it is can I use hydraulic crane? Where would I hook the chain to? Is their anything else I should know before I attempt this job I...
  10. W

    Steering 1990 Johnson GT 150

    It looks as if I may be rplacing the steering cable soon. I noticed a pretty good crack in the cable insulation and into the cable itself, this is where the cable bends when tilting the motor. My question is this an involved job of adjusting the cables somehow after the new ones are installed...
  11. W

    VRO oil pressure

    I have a 1990 Johnson GT 150, a couple weeks ago a had a restriction in the pee tube, I believe I got that remedied. I noticed when the tube came apart I lost oil pressure (on the guage anyway), so I take it that the guage works off of a vacuum. Now when I get up on plane and trim the motor, at...
  12. W

    compression

    I have been reading on this site that compression should be 100 or more with not more than 15 difference between cylinders. I have a 1990 Johnson 150 gt with compression readings of<br />90 90<br />90 90<br />85 85<br />The service guy said this was good that they look for more than 15...
See more
Top