I obtained an older outboard and I need to order parts. First I must know the year this outboard was built. The plate reads: 4AC 6EO S 139468
I'm looking for a waterpump housing and a couple of seals. Where is a good place to purchase online. Thanks, Wayne
I have a 94 JT750 jet ski engine that needs a piston, sleeve (or bore out), connecting rod and crank pin kit. I've never worked on one of these "repairable" crank shafts before and I don't know if I should bore the cylinder or have a sleeve installed, or perhaps purchase a cylinder housing. Is...
My 1994 150 Johnson Ocean Runner popped into neutral under power and left me floating on the calm waters of Matlacha Pass in SW Florida today. I had to be towed in because forward & reverse do nothing. It looks like the shift rod is moving up and down properly below the carbs although it's hard...
I ran my 1993 Yamaha 90 today after about 3 months of storage. (Plenty of oil in the engine tank) The boat ran fine at high speed for a few minutes then the engine began to falter and died. My guages are very cloudy and hard to read so I don't know if any of the warning lights are working but...
My 94 Johnson 150 watercooled rectifier is defective. The item is somewhat expensive and I would like to know if I can simply use a 4 wire rectifier like Johnson uses on the 50 to 60 hp systems? If so how would I feed the tach?<br /><br />If not, is there some other less expensive rectifier I...
I'm in the middle of a possible VRO problem related to over oiling and have not yet had time to run the necessary tests on my 150 Johnson 1995. I also have a non-working tachometer and have been reading posts related to the gray wire and the rectifer. <br />Is it possible that these two...
After ebuilding my 150 Johnson it smoked excessively when cold but when warmed up it ran reat. Now, a few weeks later it has become almost impossible to start unless I prime the carbs with straight gasoline. Very rich oil/gas is flooding out the carbs during cranking and it appears that the...