Hello Forum. Hoping for some direction. I bought this seadoo last year on kinda of a whim. Never even drove one before. And didn't check it out as good as I should have. It has the 787 engine.
It ran great for a couple of hours (stopping, starting, ripping around) then just died and wouldn't...
Hi All. Hoping I can get some help with my Sea Doo. Was running great and suddenly died while my daughter was riding it. She said it just suddenly stopped like the lanyard had come out. Couldn’t get it started again.
I’ve been running premium fuel with sea foam added.
It turns over fine, has...
Model CJ10RCDB
Serial R 7302920
Motor will spontaneously jump into reverse particularly when at high idle and sometimes is difficult to shift into forward.
I removed the lower end to check shift rods. Found top bolt on shift rod connector showed signs of wear. Also top shift rod seems to...
I am rebuilding the carb on my 2008 3.0L. There is a spring loaded cap type thing covering the idle mixture adjustment needle. Can this cap be removed to replace needle valve? If so how?
Thanks Mike
I have an Eska 1975A 5.5HP (with full pivot reverse:p) outboard I'm trying to find a carb kit for. Does anyone have a part number. I'm not really into ordering it on line if its avoidable. Would like to find one locally if possible. I'm in the Toronto area (Oshawa actually) if that helps...
I have a 2008 3.0l with an Alpha 1 drive. It has a 160* thermostat. The temp gauge (Faria) has always run around 175*. This year since I put it in it is now running closer to 200* on the gauge. I have used an infared temp. gun around the engine and the highest temp I can find is around 155* near...
Where should the cooling water exit the motor? Mine is coming out the 1/4" hole in the front left side of the lower unit. Is this right? Everything I can gather says it should come out the vent holes closer to the back above the water intake. Whadda you guys think?
Thanks Mike
I took the motor apart to repair the steering swivel and replace water pump impeller. There is a diffuser plate in the bottom of the exhaust area of the mid section. When I pulled the power assembly off the mid section this plate was just laying in the bottom. Its not real apparent where it...