Does anybody know where I can new ones?
I removed old ones to clean out the MFs they were full of sand.
Factory one are SS. The volvo store is nuts 10$ a pop
Motor 302.
fresh water cooled.
raw water cooled manifolds.
raw water cooled oil cooler.
I got water in my oil. Dip stick was full not over full. anti freeze in fine no oil no loss. It just dont seem like a head gasket.
So I removed oil cooler filled it under air pressure underwater in a 5...
Craigs list outdrive. 1977 stringer
can I test the lower unit by touching wires to a battery? unit is not in a boat.
I know one is forward other reverse unit is ground.
What should I look for or feel? prop drag with wire connected? free spin without?
I know the ohms should be 6 red to wires...
77 stringer New transom seal 5200 around seal&hull , 5200 in the screw holes, wire brushed the intermediate housing clean I just clamped the seal to it no sealant. shift wire does not leak
Im still getting water in the hull. what am I doing wrong?
First off nothing is wrong with steering.
I've lubed the 2 zerts on the intermediate housing.
i've looked in the manuals and there is no where mentioned on how to lube the cable itself.
I just what to keep my 37 year old cable in good working order.
Im thinking about remove cable end form the...
I recently bought a a 77 omc everything sweet so far.
On my volvo penta I tapped in to the raw water line for my washdown pump.
Is this possible with the OMC Without the motor running ?
I know it will work with motor running
I know the raw water pump is in the leg not like the VP.
When I hook...
The 91 octane is the recommend fuel for my motor. (AQ131D)
Up until about a month ago I could get 91 Non ethanol
Well that gone
I can get 87 Non ethanol
Or 91 ethanol
Which fuel run would you run?
Ive been looking how to get my red dot heater Red Dot R-254 Auxiliary Heater in line with a hot water supply .
I found this picture of a heater line on a aq140.
I have a aq131 in my boat. I do not have a inlet on my red tank.
Can I change the red tanks & copper pipes from a aq140 (B23 block)...
My boat had a merc 470 package.
Now It has AQ131d/SP package.
The installer did a very good job on the wiring the VP to the old Glasply dash.
Here's were I'm scratching my head. The Tilt Trim Gear assembly is shot. Motor seams OK
So i look at ebay to see what one is going for.
The used...
Can it be used?
Im getting the Point Dwell & timing dialed in. Runs a lot better thanks for all the help.
Plugs look Almost OK but not quite right. So Im looking at the carb, maybe a little rich. So I get out my vacuum gauge.
Am I blind I cant find a vacuum port.
Re: AQ131D out AQ145A in
Now your confusing me.
Me nor my neighbor are not full time dwell angle setters 1or2 a year for him me V A R Y rare.
This is very close to the meter I have
If I was set the points at 62Dg for the volvo were should the needle be on that face.
Here's what I got
80 Glasply 19.5 cuddy That originally came with a mercruiser 470 Motor died.
Later on in time someone put a aq131d/SP in its place. Looks like they did a good job. But unknown hours
I've been tinkering with this motor for a while now. Ive everything set to spec. Although I...