Recent content by ukmember

  1. U

    Starting without remotes ...

    Hi all, Im back with evinrude again having a brief spell with honda, but have a question. I recently purchased a Dory with a 60hp evinrude ( BE60TLESM ) I parted enging from boat for some winter servicing but didn't remove the remotes from the boat due to the way it was installed, now can I...
  2. U

    converting from "rude" to Honda

    Hi all, Been a member of the "rude" section for a while but have now purchased a BF45 which i pick up on Thursday. It is a 98/99 model in great condition, full service stamps and one owner from new, he recently purchased a new 40 for his boat. Now the only fault I can see is a piece of...
  3. U

    Can I do this and will it work ?????!!!!!!

    Hi all, Looking to connect an aftermarket tacho to my 30 hp 1990 " e model " evinrude outboard. Now having looked the wiring diagramme for my engine and controls it seems that the evinrude plug in tacho connects to the poss / neg and gray. Now can i connect the "RPM" part to the grey on my...
  4. U

    Aftermarket rev counter .... where to connect 1990 30hp rude

    Hi all, I have been lent a rev counter to try and work out where my engine is reving to before I change my prop to get the boat up and on to the plane. I have set the pulse to 5 just need to find where to connect the pickup to. Kind Regards Uk member
  5. U

    Carb rebuild ...... new nozzle gasket split like the original. 30hp rude 1990 metal

    Hi all, Me from across the "pond" again. Just rebuilding my spare powerhead and refurbing my carb, now on separation and splitting of carb, I noticed the nozzle gasket was crushed, is this correct ......... After installing the new one I thought i would check and sure as eggs is eggs the new...
  6. U

    No1 cylinder wet, and fuel / oil from carb when tilted up 30hp 88/89 "e" model

    No1 cylinder wet, and fuel / oil from carb when tilted up 30hp 88/89 "e" model Hi all, Been having a few issues with my motor of late, not reving when underway, but will rev when sat at the mooring and the prop is off. Anyway, im getting allot of miss fire issues with the motor and no 1...
  7. U

    evinrude25 xp ???? after the 30 had died on me for the final time

    Can any one shed any light on this model please ???? My 30 has finaly bit the dust and can have this model cheap, needs new impellor but that is no problem. What year were they available from,looks like a mid 90's model from the photo I have seen. Many thanks Uk member
  8. U

    what if my timing was 180 deg out ?????

    Hi all, I have a rude 30 1989 /90 with a cd2usl unit and I dont think it is reaching full revs ??, now I dont have a tacho but if i use the throttle linkage when the engine is running and the boat is underway it revs further due to me injecting more fuel by this linkage rather than with the...
  9. U

    EVINRUDE 30HP 4 Stroke

    Hi all, Looking at a 30hp 4 stroke next week that has no controls but was working when removed from boat. What should if anything should i be looking for the engine from the photos i have been sent is in very good condition and has been used in fresh water only the engine is a 2004 model as I...
  10. U

    Lapping a new flywheel

    Hi all, will be lapping the replacement flywheel to the crank on my 30 rude the weekend weather permitting, the reason for this is the key had snapped and picked up a very small amount to the crank. Now i have lapped valves on numerous motor cycle engines so know the basics,but the flywheel is...
  11. U

    Woodruff Key / flywheel Problems

    Hi All, Having sorted out another ignition problem (CD2USL) I now have a problem with the woodruff key snapping on the flywheel / crank, both have snapped in the same area and are the same size, im going to get 2 more from my local Evinrude stockists. Question, is it the flywheel which has...
  12. U

    cd2usl ignition module

    Hi all, Replaced the ignition module on my 1987/88 evinrude 30 this year due to the centre metalic pins coming out and then leaving me without a spark .... Have returned to do some winter maintance and the same thing has happened but this time i caught it in time i hope and refitted them with...
  13. U

    1992 / 1985 30hp flywheel differances Help please

    Hi folkes, Having resolved the ignition problems have discovered that the flywheel internally is pretty scored, now i have a spare flywheel from an earlier model, that is 2 teeth smaller but by changing the starter bendix can get around this. Now i have attached 3 pics showing the flywheels 2...
  14. U

    Flywheel differances ??

    Hi, having found the problem with the 30hp rude and ordered the new cdi from your side of the pond, i have a dilema regarding the flywheel............... the underside of the one on the boat is heavily scored from the damage caused by the cdi falling apart, i have a spare one that is the same...
  15. U

    Replacement CD 2 usl/61 "RUDE" Ignition

    Hi Guy's Having found the fault with the stator etc will post pics on the other tread " no spark this season" can anyone point me in the right direction of a non oem part for this item. Full part no is CD2USL/61 584486M. It would apear that the previous owner was a...
See more
Top