Below is a list of sites where you can find information on the year of your Mercury outboard motor.
You will need the motor H.P. and serial number.
The serial number can be found on a plate located on top of the transom mount.
Some of the serial numbers in the lists below will cover several...
Can we have a 'sticky' here with a link to a list of serial number and model years?
It seems like we get a few questions a day " what year is my motor?"
There must be a non-selling site with a list of serial number/year.
How do I figure what the tounge weight should be for my little 15ft boat?
I am redoing the trailer and need to set the axle in the right place.
It is an adjustable axle/trailer.
In another post you guys said stay away form "L" drive boats.
I am a new boater.
What is an "L" drive?
Looks like they come out of the bottom of the boat vers out the back.
Why should you avoid them?
Just a bad design, no parts...?
Thanks.
Here is what I am finding under some of the spiders cracks.
Most are just in the gel coat and I am grinding them out, but some are
into the fiberglass. The holes show up after I grind through the gel.
How should this be repaired?
Well it took me about 2 hours to get my boat in this position.
Now what?
I have a wench at the shop I will bring home Monday to lower the hull down. The ratchet straps worked to get it up but no down.
Found lots of spider cracks in the gel coat and lots of blistering in the paint. Seems to sand...
I was in Vegas over the weekend and decided to visit the lake, looking for launch sites for this summer, I had never been there before.
The lake is down about 110feet according to the park ranger. The valley of Las Vegas is draining it faster than the snow melt can keep up. Still a very large...
While preping the hull for the final primer coat I found that 1 of the splash well drain was loose.
Digging at it, it fell out. Found some rot after cutting part of the inside of the transom out.
I ordered some Seacast. I plan on grinding out anywhere a hole is and filling with Seacast...
I have searched the internet to buy carpet for my boat restoration.
Fiberglass hull with no floor, just the hull. Will be glued in.
I find marine grade and I find marine grade with rubber backing.
Will carpet with rubber backing hold moisture under it?
Will either last longer or is more...
This was e-mailed to me, thought it may be of some interest.
This is an actual emergency room photo of a fisherman who lost control of his high-speed bass boat in West Virginia .. Warden's believe that he was traveling at a speed of approximately 75 mph at the time of the accident. He was...
New here and will have many questions.
I am restoring a 1966 Powercat 15ft, 4 seater, outboard.
I bought a Merc 1100SS for it and the portable tanks will be too small.
I bought a 25gal tank for under the deck. Never installed one before.
I will be adding an electric pump, I have a deck fill/vent...
