Recent content by tgkBarney

  1. T

    Evinrude control cables

    Hmmm- where to put this topic? :confused: <br /><br />I need to replace the control cables for my Evinrude- the current ones are way to long and don't work smoothly.<br /><br />How does one measure for proper length? <br />From tip to tip or just the cable excluding the connectors?
  2. T

    Speaking of drain plugs...

    The lower drain screw on my gearcase ('77 85hp V4) had the magnet tip on it. The guy at the marina said it really wasn't necessary and sold me a plain screw.<br /><br />What do you guys think? Stick with the magnet tip or don't bother with it?<br /><br />Chris
  3. T

    1977 85hp Evinrude runs, but...

    Hello!<br /><br />Engine: 1977 Evinrude 85hp V4 Model 85793, S/N J0005666<br /><br />I purchased this engine from a gentleman who says it had not been run in a little over a year, but was running fine. I've changed the gear lube and checked the water pump. <br /><br />I am able to start the...
  4. T

    Telltale?

    Maybe I'm just a dummy.... but where is the telltale on my 1977 Evinrude 85hp V4? And how much water should I see? a steady stream?
  5. T

    Evinrude Part Number?

    Would anyone happen to know the part number? I'm looking for a motor cover seal- the piece of rubber that fits around the rim of the hood. It's for a 1977 Evinrude 85hp V4, model 85793.<br /><br />I found one at go2marine.com, but it says it's for a 1978 85hp, Evinrude part #329548.... would...
  6. T

    Gear Case FLush

    Good morning. I just acquired a 1977 Evinrude 85hp V4. I drained the gear case and no signs of water or metal shavings, but the oil was pretty dark and thick- looks like it has not been changed in a while! <br /><br />Would it be a good idea to flush the gear case before filling with fresh lube...
  7. T

    75HP Needs Parts, Crankcase Cover

    Hello-<br /><br />My name is Chris and I live in Des Moines, Iowa.<br /><br />I'm getting ready to rebuild my 1975 Evinrude 75HP 3 cylinder. I found this motor last fall and it had thrown a rod. Thought I'd get into the forum here for advice from the experts.<br /><br />I know I'll need a new...
  8. T

    Rebuild or not?

    Hi-<br /><br />I just acquired a 1975 Evinrude 75hp that threw a rod. Visible damage right now is limited to a hole in the crankcase front, and some loose needle bearings. It happened 3 years ago and has been in storage since then. I guess my first question is, am I going to be able to rebuild...
See more
Top