Will get coat stick/adhere to duralux??
Im in the middle of grinding down my fiberglass jetjon I built a year ago and want to gelcoat the sides and bottom of the boat but am concerned that I must grind threw all the duralux that I had rolled on a year ago...
Any help would greatly be...
If anyone could help itd be greatly appreciated. Need to know around about year and model of this 35hp mercury 2 cylinder single carb. And If anyone wants to buy parts off of it, motor is locked up but Im sure there are alot of good parts still.
I have a 1987 30hp mariner/yamaha I need to pull the prop shaft due to being bent. I cannot find part number c-91-78729 anywhere if someone could please refrence me Id greatly appreciate it. or if there is a way to make one id appreciate it if someone could help me...
Im looking for any tips advice measurements etc that I would need to turn my fiberglass 14 43 flat boat into a tunnel hull.. Rivers I hunt on are very shallow at times and I need to run in as low as 8 inches to a foot of water. Is it easy as just cutting out the bottom section of my transom...
So Im done trying to see what fuel issue im haveing Ive done everything. How can you determine if you have a bad power pack stator or coils? Im haveing problems with my top end missing or studdering, it runs fine until I get wot on plane. Sometimes itll run fine and others it will not some...
So Ive posted about this motor a couple times and never had a response. My 1987 30e mariner is doing it again. End of hunting season last year I finally got the ob to quit doing it then in spring I was running out of a bayou and hit a small snag nothing major and the ob started just completely...
I have the rectangle type dog ears and just cant seem to get them to seat right on my lower unit, what type do yall use??? I hate haveing to fill up a barrel everytime I want to run the boat at the house...
Ryan
Just looking at the prop today after correcting the lower unit oil and water leak, the prop shaft moves in and out of the bearing spool is this normal, does anyone elses' do this?? It moves about a quarter of an inch..:confused:
Im changing the spool bearing on my 85 force and am wondering if their is a certain tool to press the new one in? I used a socked to get the old out and the bearing didnt like that too much and she wasnt that good looking when she got out.
Well it all started with changing the seals under the water pump houseing, well then come to find out they dont make the spring looking seal for the shift rod, so I had to order an entire new assembly, ok so thats not the problem now that I have that Im looking for some good advice on the 2...