When priming my OX66 with the primer bulb I noticed that it wasn't getting firm but could tell it was pumping gas then I discovered thare was gas leaking from the exhaust at the prop. What would allow the gas to flow completely through the engine when priming engine? Any help would be appreciated.
I am thinking about buying one of these boats. Are they the same hull? Are both of them all composite hulls? What kind of reputation do they have? Anything in particular to watch out for?
Water has got in around the screws for the hatch on my raised casting deck and rotted the wood in the hatch area. I have dug out the bad wood that was sandwiched between the fiberglas and dried out everything. The bad wood extended from at the edge of the hatch opening from 1" to about 8" back...
Two days ago my 2000 model C-115 would not plane off the boat as normal and it would bog down when advancing the throttle. At idle I pulled each plug wire individually and found that one plug wasn't firing. The engine idled as fine with this particular plug wire off as on. I changed the fuel...