hi how are all of you. i just rebuilt the carbs on this motor and was wanting to know what is a good starting point for the carb adjustments. 2 1/2 turns out ??? any help would be appreciated. thnaks in advance.. raven:confused:
:eek: i went out today in our 1973 procraft bass boat with a 135 horse v 4 1975 model. it ran well but we noticed water in the bilge.. and we turned the pump on and it took a little bit to pump out. we dropped anchor and sat to see where it was leaking it did not do bad BUT when we would move it...
hi fellas, i took my carbs off and tore them down today and did like you said, these carbs were very very clean throughout. needle valve was fine and looked like new. i did this because when you go to accelerate it acts like it starves for gas.. and falls on its face. Tashaddy said to rebuild...
:( i have a 1975 evinrude 135 outboard v-4. we took it out yesterday and it would idle fine and go into gear fine. but when you went to acelerate it would stall and fall completly on its face and would die. this motor then would start right back up and when you put it neutral it would rev fine...
my uncle has a 48 spl outboard that will not idle. we took the carbs off and had them cleaned and put them back on only to do the same thing. what could be causing this problem? it runs fine every other way. any help is greatly appreciated. how good are these motors and are there any problems...
hello, i was wanting to know what kind of lower end gear grease to use in this motor. i was also was wanting to know is this electric shift or mechanical shift. Thanks in advance Raven:D:confused:
he fellas, i was wanting to know where you check the lower end grease in this motor at, and if it needs it what kind goes in it?? thanks in advance.Raven:D
this boat i found on accident. the guy wants 1000.00 dollars for it, but the motor is missing the outboard side of it. what is this boat worth and how hard to get the outboard parts?? and cost of course.. thanks
i would first off thank you all for your opinions and knowledge. i took the floor out of my boat and cleaned it all up. the stringers seemed to be fine so i am starting to put the floors back in. what do i use on the floor on the bottom of the plywood and what do i do too the top after...
hello all, does this motor have a charging circuit of any kind that will charge the batteries or better off just to run two batteries?? thanks in advance Raven
hello fellas, i just had this 76 procraft given to me and was wanting to know about this boat. it has a 135 horse evinrude on it and we got it running today. the floors were a little weak so we took the carpet up and it has like a thin layer of fiberglass over plywood. when we redo the floor how...
