I have a 9.9 Yamaha and I need a new shift control cable for the tiller handle, and for some reason nobody lists it by my model number. can anyone please tell me the part number for it? the sticker on my motor reads:
6G9 F9.9ELHY
I also attached a photo of the decal.
Thanks
I am replaceing the head gasket on 120hp, What is the best way to get the old gasket off the block and head without damaging either?
Also, whats the best way to get the salt build-up out of the water jacket?
Every time I post a reply or comment, the post will disappear and then if I repost the first one will reappear but will then disappear later. I am loosing as many as the last 10 or 12 posts in a thread.
Is anyone else seeing this? Or is it just me experiencing this
1988 Johnson 120.
I have been having an issue with this motor for some time and I think I may have found the problem, but would like another opinion.
I checked the compression and I have 100+ on all cylinders so I figured I was ok. The motor continued to have a mis so I checked it again same...
I found this on C/L, is it a good deal or is it overpriced? I realize it will be alot of work to get it going, but I am wondering what the most I should offer for this is.
http://miami.craigslist.org/brw/boa/1878697756.html
I have been having some issues with my motor and have found many many threads about the same thing. Problem is most people dont post what they did to fix the problem, so then we get a buch of threads about the same thing and still no answers for future people with the same problem.
PLEASE post...
Just wondering...I am in need of a few parts and have noticed a few used parts that look the same but I am not sure if they are interchangeble without knowing what they came off of. is there a way to see which parts from different years will interchange with other years, (looking at brp numbers)
A buddy of mine bought a project boat last week and the floors felt weird when I was in it tonight.. so we decided to pull the carpet to see what was going on and one thing led to another and we ended up haveing half the deck pulled out.
The amazing thing or should I say unusual thing was the...
1988 johnson 120hp, motor was not charging, tach was not working, all test results indicated rectifier needed replacing. I replaced rectifier and it is still not charging. and tach is still not working
I just replaced the rectifier on 1988 Johnson 120hp. when I put the wires back on I noticed there are 3 purple wires and the wiring diagram only shows 2. it looks like one from stator or timer base one from CDI/power pack and the third goes to a small plug which then leads to VRO, the VRO on...
I purchased a new rectifier for my 1988 120hp Johnson, the gasket was not included. I am not near a parts house and when I look online at the BRP site it says the gasket is obsolete. can I use silicone or do I need to try to find a new gasket as the old one is not usable. if I was near a...
My neighbor is in need of a mobile marine mechanic in the West Palm Beach area, if any of you can recommend one in my area I would greatly appreciate it, I have had a lot of trouble finding one that is dependable, they show up take the motor apart and then leave and never return some even taking...
I have noticed a lot of threads about cleaning or restoring the exterior finish of boats, and I was just wondering if there is a "suggetion Box" type of area here on iboats? I would like to suggest adding a new category or sub category possibly under the restoration section. I know very little...
How can I tell if I have either of these features, and how do I disable them to adjust the timing. I read a post here that mentioned if I do not disable them it could make my motor run rough, which is the problem I am having. (1988 Johnson 120 (J120TLCC)). There seems to be some confusion in the...
