Recent content by pogi

  1. P

    Gimbal Ring Bolts

    Hello, I asked this question a few weeks ago and got no response so here goes again. I have a 1978 20? Apollo, with a 305 V8, I believe the outdrive to be an MC-1. The steering is very sloppy and I?m trying to find the two bolts on the gimbal ring that need to be torque to 50-55 Lbs. I can?t...
  2. P

    Steering play

    Hello, I have way to much steering play and can't seem to find the two gimbal ring bolts that are torqued to 50-55 Lbs. I wanted to check them as per the manual. Do I need to remove somthing to get at them? The drive is an MC-1 and the engine is a 898 GM 305. So my question is where are these...
  3. P

    Mercruiser 898, GM 305 TACH Problems

    So I'm out on the water and I notice that my tach is not reading correctly, it's kind of jumping around. By the time I got back to the dock the motor died and there is now no spark at the coil wire. Could the TACH be the problem as in grounding out the coil? Thanks.
  4. P

    Sticky lifter

    Hello, I ran my boat on sunday and it ran fine, then today when I started it it sounded like a stuck lifter. So I pulled the valve cover and sure enough the lifter in question was sticking. Can a sticky lifter cause a bent valve? After turning the engine over without starting, the noise went...
  5. P

    Oil & water gauges

    Hello, I hope someone has an idea about what is going on with my gauges. When I turn on the key but don't start the engine both oil press. and water temp gauges jump up, oil to 45psi and water temp to 180. Now the boat engine is cold and not even started yet but thats the reading i get. Could...
  6. P

    Running on Muffs

    Hello again, I'm doing some trouble shooting out of the water and need to know about running on muffs. How long can I run the engine on the muffs and is it ok to shift into gear while on muffs also is there a max RPM. Thanks for the help.
  7. P

    Wires at the outdrive

    Hello found some cut wires at the outdrive are these needed? and what are they for? Boat seems to work fine without them being connected. Merc 898, not sure of the outdrive. Thanks.
Top