hello, i have an old honda 2hp 4 stroke, changed float needle, all gaskets, spark plug, fuel, soaked carb in carb cleaner overnight, cleaned jets and yet it still refuses to start now and again when hot, when changing quikly from tickover to fast it hunts, nearly stalls at the point where the...
hello, my 1980s 2hp , 4 stroke starts fantastic when cold, pumps water as it should ...but once turned off , refuses to start again,,any ideas, thanks tony
hello ,ive a 25 hp ,2 cyl,merc outboard ,im after the part number for the cork gasket that fits onto this item,,,,8149-cover,strainer,as mines leaking ,or if someone can offer an alternative ,,thanks tony
hello,ive a 25 hp blueband and its the regular reverse problem ..can i adjust anything in the gear housing area to enable me to get reverse ,its not the selecter in the top section as this is fully adjusted ,,thanks piperdog
forgot --it okay in tickover then un-engages at any revs
hello,my little honda 2hp at normal running temp,cuts out when i go from high revs to tickover( unless its done very slowly),once cut out its a s--t to start ,adjusted mixture screw and this seems ok ,so i presume its flooding ,,any ideas ..thanks piperdog
hello,,is there a cut out switch for the cd-18,if not how do you turn it off (without running out of fuel and disconnecting the spark leads ),,thanks piperdog
hello,it seems the fuel mix is 24-1,but as todays oils are far supperior than back in 61,can i not use 50-1,or doesnt it work this way,,,thanks piperdog
sorry its 5.5 hp
hello,can someone give me an idiots guide on the correct procedure to start a 1987,90 hp v4,( cold ),,ive isolated the vro and using pre-mix..thanks piperdog
on my powerpac (cd4 583336 )the earth lead has rotted away and broken at the moulded plastic ,is this going to cause me a problem and if so can i open the box upsomehow and fix..thanks piperdog
hello,ive a 1987 ,90 hp evinrude ,can you by the pin connector fror the rev counter seperate and wire it up yourself or do you have to buy the complete harness ,,thanks piperdog
been offerd a 1987 ,90 hp vro ,v4 evinrude for ?800 ($1350 )if all works as it should ,is this good money and what problems do they suffer from,,,thanks piperdog
