Recent content by nslsubject

  1. N

    Test tank for jet drive?

    I have a 1993 Evinrude 90hp jet drive on my 16' jon boat. Is there a jet drive version of muffs available? If not, and I have to use a tank, is there some clever way to keep the engine from emptying the tank in about 5 seconds? Would it work just to put it in reverse so the deflector is in...
  2. N

    Bendix gear and temp switch

    No, they are not related (as far as I know). I have a 1993 Evinrude 90/65 model# E90JLETS with two problems: 1) The bendix gear is pretty chewed up and sometimes jams in the flywheel teeth (which are in good shape) when I try to start. It jams tight enough that the starter won't spin, won't...
  3. N

    Manual for 1993 Evinrude 90/65

    I have a 16' Lowe Roughneck tunnel hull with a 1993 Evinrude 90/65 Jet drive (model# E90JLET). I found (and ordered for $85!) the repair manual for my engine listed in the 65hp section at Ken Cook but they didn't show an owner's manual. They do show an owner's manual for model# E90TLET in the...
  4. N

    WOT RPM for Evinrude Jet Drive?

    I have an 1995 (or so) Evinrude 90/65 hp factory installed jet drive. WOT right now for my set up (16' Lowe Roughneck, side console, two 6-gal external tanks) is about 4500 rpm. Most of the posts I've seen indicate around 5500 rpm should be normal for a 90hp. My question is this: Does the...
  5. N

    Serial number information

    I recently purchased my first boat, a third hand 16' Lowe Roughneck Tunnel Hull with an Evinrude V4 90/65 factory-installed jet drive. At some point I will no doubt need owner's manual, repair manual, parts, etc. Where can I go to find out information about the boat and motor from the serial...
See more
Top