i need to turn my boat over to redo the paint and check it out close for cracks. its a 23' cuddy. can i hang it by the front ring and the 2 rings on the transom by chain hoists and than roll it over. just want to make sure that the weight of the boat can be held by those points. i will support...
has anyone ever done a conversion to an aluminum johnboat to where they installed a honda car engine into it? im thinking of doing that. kinda of a speed nut and 45 is not fast enough for my 17' nitro bass boat. and i just want another project. i have heard of the jetski swapps into johnboats...
what are the opperating rpm's of this engine. i want to run a 4 blade and need to know what the max is. and should i run the 4 blade near the max for the most speed. or will i save the engine some life if in the lower range. thanks
i have a 1994 nitro 170 bass boat and the trim unit will not hold the engine in any up position. it sinks till it hits the ground (when on the trailer) or in the water. last year i replace the fluid and cleaned the pressure relief valve between the motor and cylinder. i tested the opperation of...
its story time... i just bought my 1994 nitro 17' bass boat last summer to go to canada. well i was running around a river in my area and bumped a rock and bent the original prop on the engine. in the fall i bought a michigan 13X19 and didnt have a cahnce to run it. this weekend it went to the...
