Re: 1982 Johnson 70hp water temperature sender/sensor - answer maybe!
Hi Six,
Attached is a photo of the gauge - no macro I'm afraid so a bit blurred.
No manufacturers name although the tacho and hour meter are both OMC.
The image on the face is a bulb thermometer or similar idea and scale...
Hi Folks,
I have just replaced the '0' ring at the base of the trim/tilt motor housing and cleaned up the seat because it was leaking. All went well and leak has gone.
Now though, I have noticed, not a leak - that sounds too much - but a slight weeping around the endcap of the starboard trim...
Hi Guys,
Firstly, please pardon my ignorance here, but I'm feeling my way into this!
I want to remove the exhaust side of the block to check out the internals and check for corrosion.
Before writing here I tried on the Tinterweb to see how to remove the lower engine cover, but kept being...
Hi Guys,
I wonder if you can help with this one?
I get no chirp from the buzzer when I turn on the ignition, so I was concerned that the buzzer was u/s. I checked it by earthing the temperature switch to the head and it buzzed away happily, so the buzzer works. I have read the threads on...
Hi Folks,
I am in the process of bringing this 70 up to scratch and re-doing some of the things undone by the previous owner.
One of those things is getting the (I believe) OEM temperature gauge to work again.
I have found a (loose and taped) tan wire near the red plug that, when shorted to...
A couple of weeks ago, I bought a 1977 14ft Cruise Craft Rogue with a 1971 Evinrude 70 hp, both in very good apparent condition - as was the trailer. All suggested a sense of 'well looked after' especially when the original, almost unmarked, two-tone grey trim still carries the embossed Cruise...