Recent content by kthurman1

  1. K

    1966 33 hp prop. cone

    I am looking for a replacement cone for my 33 hp. the omc is 305294 does iboats sell a prop. cone that will work on my boat. thanks for the help.
  2. K

    1966 33 horsepower evinrude impeller

    The impeller is not pumping any water. I pulled the lower unit off today and the impeller still looked brand new and the little pin was still in place and the housing looked ok. It was pumping water until a couple days ago. It seems like there is alot of bubbles coming up from around the gear...
  3. K

    1966 33 horsepower evinrude, couple questions

    First, what would make this motor go through impellers. I have replaced it twice already this summer and I was wondering what would cause this problem. Second, I was changing the gear oil and found water in the gearcase. The little plastic seal around the drainplug was messed up, would this...
  4. K

    1966 33 horsepower evinrude forward problem

    Started making a vibration or rattling noise when I was traveling down a lake. Now when I try to put it in forward gear it makes the same noise for a two to three second period before it goes into forward gear. It goes into reverse with no problem and no noises. Stopped running it because I did...
  5. K

    1966 33 hp evinrudefuel pump gas problems

    I changed fuel pumps because the other one that was on it was the wrong one and would only run good when I would squeeze the bulb. I put on the correct fuel pump that I ordered from Sierra, but now gas is coming out of the exhaust and will not run at all. The first time I tried to start it and...
  6. K

    1966 ski twin 33hp fuel pump

    I was wondering if anyone can tell me what the correct fuel pump for a 33 hp evinrude looks like. The one that is on it at this time is square (I don't know how else to describe it.)and does not look like what I am finding online that should be the right one. I was having problems with the motor...
  7. K

    71 evinrude 33 horsepower gas problems

    I have a 71 evinrude 33hp that has had the carb. rebuilt. It will idle fine but has trouble when I try to give it gas, it acts like it is not getting any. I can squeeze the primer bulb and it will run fine for a while but always goes back to same problems. I was wondering if this sounds like a...
Top