I just received my Solas 9.25 9" from iboats today and installing it but the old thrust washer doesn't seem to sit flat( flush) with the new prop. Is that normal , have any of you guys had the same problem ? This is for my 15 hp Johnson... Thks any help greatly appreciated
hey guys just received my new prop that Ive order from Iboats today its a 9 .25 9" solas. Ive try installing it using the old thrust washer and it doesnt seem to fit. Although it fit but it doesnt fit flush. Have anybody have this problem. Ive aready tried contacting Iboats but they dont know...
Hey fellows any Inputs appreciated. I have a Johnson late 70"s 15 hp running with original prop at
9 1/2 x10 pitch. I've recently added 3/4 plywood flooring to my boat and now loosing mph. By myself before i was getting approx 20 mph. With 2 person 16 mph and with three I get 13 to 14 mph ...
Re: 1975 15 hp johnson leaking gas on its side
heres my numbers for the compression test. 110 On bottom plug and 100 on top. Any ideas why its running on one cylinder?
Is there any way to check and see if my top coils are bad or weak?
Hey there guys I have a leak in my motor. I found the leak when I was rebuilding my carb. Its spitting out gas and oil on its side on the top bolt, heres a pics of the motor where its leaking from to give you guys a clear picture.The motor starts up and runs fine at full throttle but dies when...
Im new here and I heard this place is good site if I needed some help. I hope you guys can help me out all imputs appreciated.I have 1975 15 hp Johnson. My sparks jumps at 1/4 both plugs and are bright blue. Compression tested at 25 to 35 on each cylinder. The test wasn't accurate because the...
